Kawasaki UTV SxS Forum
This forum is dedicated for Kawasaki UTV, SxS owners. Forum is for Kawasaki UTV and SxS topics including the Kawasaki Mule, Mule Pro-FX, Pro-FXT, Pro-MX, Pro-FXR, Mule 4000, Mule 4010, Kawasaki Teryx, Teryx4, Terryx KRX, Teryx KRX 4, and Kawasaki Ridge and Ridge XR.
461 topics in this forum
-
- 0 replies
- 5.8k views
-
-
- 2 replies
- 7.4k views
-
- 0 replies
- 4.4k views
-
- 0 replies
- 4.2k views
-
- 0 replies
- 3.2k views
-
- 0 replies
- 4.3k views
-
- 0 replies
- 4.3k views
-
- 0 replies
- 4.4k views
-
- 0 replies
- 3.9k views
-
- 0 replies
- 3.6k views
-
- 0 replies
- 4.2k views
-
Latest Posts
-
Russ When I fabbed the first mount A belt dealer went to great lengths to find one`. He finally found one like you about 47" but only available in a width of about 1". This belt didn't last any time and it shredded. I modified my mount to allow the stock belt tio fit. On the stock belt, do some googling. I found one under 100. -
I replaced the defective battery and everything is back to normal. Installed digital volt meter shows 51.9 volts when fully charged. Am again able to climb the steep hills on my property. I did not replace the expensive Discovery battery. I used a deep cycle marine 6 volt battery. -
Sorry to hear that, good that you found a solution. -
-
By Homeowner A · Posted
Is there a code reader available for the Coleman UTV 400? I tried using the HUD ECU Hacker software and cables/adapters but no luck OBD to delphi 6 pin and KKL VAG as well as ELM327. Will not connect. I was able to get it to connect randomly a couple of times, but haven't been able to since. I was able to clear and read the codes briefly. I'm aware of the Tiny Scan 301 but it doesn't seem to be readily available. There's a few out there but they are expensive.
-
