Quantcast
Jump to content


Hisun UTV SxS Forum

This is for all of you Hisun UTV, SxS (Side by Side) owners. Discussions about Hisun UTV specific topics including Sector, Strike, and HS models.


535 topics in this forum

    • 0 replies
    • 1.7k views
    • 3 replies
    • 3.9k views
  1. Hisun HS 550-750 Service Manual

    • 0 replies
    • 10.9k views
    • 0 replies
    • 2.7k views
    • 0 replies
    • 3.6k views
    • 0 replies
    • 3.8k views
    • 0 replies
    • 2.2k views
    • 0 replies
    • 2k views
    • 0 replies
    • 3.1k views
    • 0 replies
    • 2.4k views
  2. Injectors

    • 10 replies
    • 3.9k views
    • 0 replies
    • 2.6k views
  3. E1 batteries

    • 8 replies
    • 8.6k views
  4. No crank issue

    • 6 replies
    • 6.8k views
    • 0 replies
    • 2.2k views
  5. ys 400

    • 1 reply
    • 2.2k views
    • 53 replies
    • 29.3k views
  6. Hisun Wiring Diagrams

    • 0 replies
    • 6.7k views
  7. 2013 700 Hisun Camplate

    • 0 replies
    • 2k views
  8. Hisun fuel gauge

    • 1 reply
    • 8.9k views
    • 1 reply
    • 2.2k views
  9. Hisun 800 wont idle.

    • 4 replies
    • 7.7k views
    • 1 reply
    • 5k views
    • 1 reply
    • 5.8k views
  10. Ys 400

    • 0 replies
    • 2.2k views
    • 4 replies
    • 5.6k views
    • 23 replies
    • 13.6k views
  11. Hisun E1 back up noise

    • 2 replies
    • 5k views
    • 5 replies
    • 9.3k views
    • 8 replies
    • 7.5k views


  • Latest Posts

    • I assume you checked the fuses?
    • Hello, I have a mule 4010 trans that appeared to overheat based on the temperature light on the dash and it went into limp mode.  No steam though.  After letting it cool and the next day, I drove it around quite a bit and it did not have any problems.  Any ideas on this.  Do thermostats work intermittently?  I would like to fix the problem, looking for advice.  Many thanks 
    • No dash fault codes and I’m not advanced enough to check the sevcon.
    • What are the fault codes. Either on the dash, flashes on the sevcon controller , or downladed from the sevcon.  
    • My Axis 500 has been operating properly for almost a year with Zero problems. While I was away my granddaughter & friends were riding & playing in the snow. They went to the gas station to fill the tank & the vehicle would not start afterwards. I BEEN GIVING MULTIPLE STORIES: The ATV will not start. When I turn the key I can hear the fuel pump come on but nothing happens other than that.  - NO CLICK - NO OTHER NOISE *I CHECKED THE BATTERY 12.43volts *I replaced the solenoid inside the battery compartment.  Seems the next electrical component in line has battery connections IN & motor connections OUT with 2 other small wires connectedaswell(I do not know the name of this component). Can anyone help? I can not find an ordered list of electronic components starting at the battery. Can anyone help with this? Thanks in advance for any help.  
×
×
  • Create New...