Leaderboard

Mine does the same, but not as bad as you make it sound, IMHO, this is caused by the play around the bolts, one of my reasons for using longer bolts with shoulders, Also, IMHO, the fix would be to remover the smaller half of the case and loosen the ring bolts and try to adjust, then tighten, then pull one ring bolt at a time and reinstall with loctite. JUST MY 2 CENTS WORTH

Ok I havent had a lot of time to work on putting my rear diff. Back together , So last weekend I finally installed the new bolts, a couple new bearings, ( input shaft bearings and the cone side bearing).. Also a few shims ."BUT" when I finished puting the cover I noticed that, while turning the input shaft on one revolution of the out put shafts, the input shaft will go from nice and lose to very tight,, it seems to me that the ring gear is not centered, question is.. Is this a common problem? Posible solutions?? Thanks in advance...