Leaderboard

For a 16 digit PIN/VIN, the 9th number indicates the year. Hence, in this case, the OP's RTV is a 2006. Which is the same year as y RTV:

I had mentioned in a previous post that I had removed the front anti-roll bar from my 2020 Outfitter 400; I ran that way for a month or so without noticing any downside however recently I installed a 'suicide knob" (see below) to assist my Parkinson's disease affected arms in turning the beast--but after doing so i found that in the quicker, tighter turns the knob permitted the vehicle would nosedive a bit, dig in, and plow on hard surfaces--not scary, but quite noticeably. So I put the bar back on. Then today I got about 1-1/2 miles down the main road on the nearby power lines, turned around and came home to take it off--with the bar on, at 25 to 30 MPH, the front-end of the beast jumped like rabbit at each bump in either wheel rut., for a nearly brutal and quite uncomfortable ride. the bar (20 mm solid steel) is far too robust for the weight of the vehicle. The front bar on my 3900 lb. Infinity M37 is 30 mm... suicide knob--for you younger folks:

Nice stone work. Side note...If that's a typical flow there, then you've got enough to generate some free power. Even more so if there's a substantial drop from the source. But with just what you have there, you could easily power enough lighting to nightlight that beautiful stone work. With a ten foot or so drop from the source, you could power most of the house.

4’ diameter culvert my wife reinforced with local ‘found’ rocks.

I would suggest milk crates for holding a rock, or anything that might roll around. They're more easily secured too.

I installed a colder plug , original plug is: BPR5ES, I installed BPR4ES. Documented hrs and will see how long it goes. Thanks for responding !!