Quantcast
Jump to content


Verno

Members
 View Profile  See their activity

  • Posts

    43

  • Joined

  • Last visited

  • Days Won

    2

 Content Type 

Everything posted by Verno

  1. Verno
    Innovation at its best
  2. Verno
    Channel locks or a chain wrench
  3. Verno
    Just a thought. You should have a crankcase vent for the pressure to escape buy it may take more pressure to open. You're welcome.
  4. Verno
    With a small nozzle could you fill it through the dip tube. I've set up like that to fill a front diff through the vent line.
  5. Verno
    Look for a round hole about 1 and a half in. Toward the center of the skid plate. The drain plug should be accessed there. Should not have to remove the plate.
  6. Verno
    700 miles, bought used. The short setup on the 2017 left with no flex pipe was doomed for problems. The upgrade was done to 2019 models. I welded mine twice before installing the upgrade. Even at the cost and my labor it was worth it.
  7. Verno
    Wish o had known. It cost me $900 to upgrade my 2017
  8. Verno
    Normally you can't go wrong with a Honda, but it depends on he previous owner. Heard good things about the CF Moto. Hard choice
  9. Verno
    Double check exhaust between head and muffler. I had a 2018 cadet 750 that had a crack that caused the same issue.
  10. Verno
    Contact Craig at Motorcycle Doctor in Camdenton Mo. My complete upgrade kit was a tad over $900. It took about 3 hours. Well worth h it
  11. Verno
    Craig was very helpful. I also put a yoga mat under the seat to muffler that noise. It all helps. Good luck
  12. Verno
    Bought the cadet used. No warranty. Got the upgrade at Motorcycle Doctor in Camdenton Mo, close to $900. Dealer was closer to 1300 installed.
  13. Verno
    The exhaust upgrade does not do much for the noise, it just removes the likelihood of breaking the pipe going to the muffler. Most of my noise cam from a cracked pipe. It helps to duct the air piping from the clutch to the rear of the cab. Both intake and exhaust. Mine runs 5500 rpm at 40 mph. 6000 at 45. The gas mileage was much closer to 25 mph.
  14. Verno
    Ditto. Motorcycle doctor is a great resource for parts and knowledge. Very friendly and helpful.
  15. Verno
    Wow, now I'm glad I traded mine out at 1800 miles and 120 hours. I was wondering if I made the right decision. Mine never gave me a bit of problems other than the exhaust. Sorry to hear your problems.
  16. Verno
    There are a few on my area. The 5 seater is a big hit. Haven't heard any negative comments. Hard to go wrong with a Honda. Although I just purchased a 2020 General. I think they have the bugs worked out by now
  17. Verno
    It did not seem to alter my idle speed. I wrapped mine initially, but turned red quickly. I removed wrap and installed a shield to deflect the heat from the u-joints and piped the clutch discharge air toward the exhaust pipe at the expansion pipe. You might try unplugging your exhaust temp sensor to see if it effects your idle rpm. I ran mine with it unhooked. Seemed to not make any difference. Much better exhaust system. Good move and good luck.
  18. Verno
    Might try your brake light switch. If it doesn't know your foot is on the brake, same result.
  19. Verno
    Mine would all work but the front diff light did not show some of the time.?????
  20. Verno
    Does the turf mode / rear diff lock work? Does it send power to the front diff buy both front do not light up? Mine would lock in the front diff but not light up.
  21. Verno
    My Cub challenger had efi, not a carburetor. If yours is the same, I would start with ejector or sensor.
  22. Verno
    Might be worth a try. Measure eyelet diameter an length to match up an automotive or m/c shock. Save some $$. Make sure load rating is equal.
  23. Verno
    Ive put 1800 miles on my 2017 Cub challenger from yardwork to Colorado mountains. Built like a truck. Nice price range, loaded with all you need. Go for the 2019 and up to get the upgraded exhaust. Only downside is top speed of 45 mph.
  24. Verno
    Tire. $80. Wheel _$ 45 Bolt pattern includes 4 x 110 mm
  25. Verno

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...