Jeremy ....

The only ones I know of are spacer lifts and they only gain 2 inches

I did use chains for one year but most times I just had a bed full of firewood to help with traction. I would take care a big drifts a little at a time with the plow angled away and if the snow was really deep I would keep the plow about 3-4" above ground for the first pass. My 2019 Pro MX has less issues as it weighs 500 pounds more on its own with an extra 4 inches of ground clearance but it also needs a 6 foot plow just to clear the wheel tracks when the plow is fully angled

With my old Mule 610 I usually spun tires before having an issue with power using a 5 1/2 foot plow

I haven't broke one of those on my Eagle or KFI plows, I did lose a few bolts that holds the blade on on the Eagle plows

Even those Titan heaters aren't as good as they were many years ago You might want to look at the propane heaters for golf carts that go into cup holders, I would worry about them melting the soft cab. I put an Inferno heater in my Pro MX but even the MX doesn't heat up real fast or pump enough water through the system to get my cab toasty warm but it will melt the snow off the polycarbonate windshield in weather colder than 10 F and the Pro MX was only $3000 more than my 610 back in 2006

I used a Mule 610 for plowing snow for about 12 years using a steel cable and that was with a 66" v plow and only broke the cable once. On my Pro MX I have a 72" plow using a winch with synthetic and have broken that rope at least twice in less than 2 years of plowing. I am considering going back to steel cable/roller fairlead/or using a winch strap made for a boat trailer

To run wiring for a winch or to install a heater

I plow snow with my Pro MX and it did very well although I didn't get to plow much over 6-8 inches at once. I pulled a snowmobile uphill through 6 inches of snow and did slip some with 4x4 and differential lock on. It is a nice ride on the trails but not as nice as the Pro FX models with the wider and longer wheel base.

My father had his picked up early yesterday and it was dropped off about 5 pm yesterday. I don't think the change to the ventilation system is going to fix the problem as it is still likely that condensation will freeze in the new breather system

Our local dealer closed shop today because of new emergency laws. They aren't sure when they will open again

I am glad there isn't an issue with the steering as that would likely affect my Pro MX as well as I would bet that the EPS is the same

You should ask the dealer or Kawasaki to have the 3 year warranty start from the day you pick it up or when it is delivered

I paid just over $7000 for my 2006 610 when it was new, my new pro mx was just over $10,000 and I think it was worth it, but I also sold the 2006 for $2700. The largest dealers have the bigger discounts

Sounds like a good excuse to buy a new model

Tell them you want to cancel your purchase if you can't take possession

I wonder if it involves the valve cover breather freezing up in cold weather causing oil leaks

You may have to pry it up a little for it to move towards the rear of the vehicle. I have mine off twice

The relay is mounted near the battery because of the conductor length

My plow is a 72" by KFI and it is heavy duty. The push tube and plow weighs as much as my eagle push tube and 66" V plow I had on my 610. The KFI plow mount for the Pro MX does have a built in 2" receiver hitch. If you get a dash mount switch for the dash, cut the hole from the back side of the dash