Michele

I'm having a similar issue with my Axis 500. It seems to bog down and struggle, particularly on inclines/hills (see video). Frustratingly, it also only happens intermittently, more often when the machine has been running for a while (I use it for farm work only). So far I have: Replaced fuel filter Replaced fuel injector Replaced MAP sensor (reset ECU after) Replaced spark plug Verified air filter is clean Verified no obstructions in exhaust I only run it on 91+ gas and put a can of seafoam through it to no avail I did previously have an issue with a failed one-way bearing, but this particular issue predates that failure. I replaced the one-way bearing a few months ago and inspected the wet clutch, primary/secondary clutches and belt while I was in there-didn't see anything of concern. Where do I go from here? IMG_9433.MOV

I installed this yesterday and yes, the universal mount is a total pain. As plowdaddy said the slots to receive the U-bolts are off just enough that the bolts don't sit properly. I basically forced it on but now that the plate is installed I've noticed my turning radius is now restricted-I can't make sharp turns without rubbing up against the mounting plate because it's so wide. Anyone have success? Debating whether I should just spend the money for a new plate or try extensively modifying the universal one...