Search the Community
Showing results for tags '3d'.
Found 7 results
-
View File HS400 Seat Belt Defeat and Oil Filler 3D Here are a couple more 3D printer files for the HS400/Coleman UT400 & Outfiltter 400. Included in the .zip file are my version of a seat belt interlock defeat insert (SeatBeltThing-01.stl)and an oil filler adapter allowing a 1/2"I.D. hose to be attached making adding oil a less messy operation (OIlFiller-whole-03.stl) --both may also work on other UTVs with similar the seat belt connectors and a 3/4" x 10 threaded dipstick... Submitter cliffyk Submitted 04/20/2021 Category Hisun
-
View File 3d aux switch plate and placard mount Here is a couple more 3d printed goodies, a plate that uses the existing knockouts in the dash plus some Velcro pads to mount some rocker switches for a no-drill solution, and a mount for a slow moving vehicle placard on the tailgate. Submitter tsheh4 Submitted 04/25/2021 Category Coleman
-
18 downloads
Here are a couple more 3D printer files for the HS400/Coleman UT400 & Outfiltter 400. Included in the .zip file are my version of a seat belt interlock defeat insert (SeatBeltThing-01.stl) and an oil filler adapter allowing a 1/2"I.D. hose to be attached making adding oil a less messy operation (OIlFiller-whole-03.stl) --both may also work on other UTVs with similar the seat belt connectors and a 3/4" x 10 threaded dipstick... -
12 downloads
Here are a few little parts I made for my new coleman 400. One is a dummy seat belt clip to make the speed limiter think a belt is engaged (for diagnostic purposes only, do not ride without your seat belt on.) Another is a replacment for the circular grommets in the front corner of the bed. The last is a replacement for the rectangular cap at the rear of the frame near the hitch. Parts may need a little sanding depending on your print settings. Enjoy! -
View File Coleman HS400 3D printed parts Here are a few little parts I made for my new coleman 400. One is a dummy seat belt clip to make the speed limiter think a belt is engaged (for diagnostic purposes only, do not ride without your seat belt on.) Another is a replacment for the circular grommets in the front corner of the bed. The last is a replacement for the rectangular cap at the rear of the frame near the hitch. Parts may need a little sanding depending on your print settings. Enjoy! Submitter tsheh4 Submitted 04/16/2021 Category Coleman
-
Hey everyone, new to the forum, just picked up a coleman 400 from tractor supply this week, and of course it was missing a couple small plastic parts. Being as I have a handy 3d printer laying around, I just made new ones. In the downloads portion of this site under the coleman section I uploaded files to print new circular caps for the tie-down holes at the front of the bed, a new cap for the end of the frame near the hitch, and a dummy clip for the seat belts. Disclaimer, always wear your seat belt while riding. That being said feel free to download and print! Check your local library for a printer if you don't have one, or there are online printing services available.
