Search the Community

My 2006 Joyner Commando is locked in 4WD. When I flip the switch on the dash, the Dash LED swaps properly between 2WD and 4WD, but the unit stays in 4WD. The 3 wire sheathed cord broke (after the problem started) at the rear connector so I can't check for continuity from back to front, but each "section" of wiring is good The owner before me did some really "hinky" wiring under the dash, so I want to start at the actuator itself before tearing apart the wiring loom at the dash. The actuator has three wires coming out Red, Grey, & Green. I can not find any info on which wire does what (my understanding is that with no power to the actuator, the unit defaults to 4WD which seems to be where I am. So: Has anyone heard/had this issue? Does anyone know which of the 3 actuator wires does what ( I can't find any info/ schematic)? Part # for a replacement actuator, if bad? Thanx in Advance, Dan