Quantcast
Jump to content


Recommended Posts

Posted

Hi All, again,

Now the Landmaster will not engage in Forward or Reverse, less than 20 hours run time.

Did a quick diagnostic with Navitas Dashboard App, problem:

Bus Under Voltage Fault

Description: Voltage on controller B+ has dropped below 18V
Check batteries, solenoid and connections
(3-1)

Email problem to Navitas.

Still 50% battery supply, charging anyway.

Will check items above plus wiring tomorrow, sun going down.

D. Newton

American Landmaster, EV, Purchase Aug 2022.

Extras - Power Steering, Roof, USB port.

Posted

I noticed you added some manuals for your American Landmaster EV, thank you for sharing. Hopefully you will figure out the issue. This is one of the few EV topics I have seen, but I'm sure it'll grow as EVs become more widespread.

Here are your manuals. I edited the screenshot and descriptions.

 

Posted
On 11/10/2022 at 6:55 PM, D. Newton said:

Hi All, again,

Now the Landmaster will not engage in Forward or Reverse, less than 20 hours run time.

Did a quick diagnostic with Navitas Dashboard App, problem:

Bus Under Voltage Fault

Description: Voltage on controller B+ has dropped below 18V
Check batteries, solenoid and connections
(3-1)

Email problem to Navitas.

Still 50% battery supply, charging anyway.

Will check items above plus wiring tomorrow, sun going down.

D. Newton

American Landmaster, EV, Purchase Aug 2022.

Extras - Power Steering, Roof, USB port.

Hi All, Well I did some troubleshooting (shotgun work), and I got the vehicle working.  I think the connect was not seated fully in the DC/DC Convertor (48v to 12V).  Not sure, I disconnected and reconnected a lot of wiring connectors.  See Pic1

I was using the phone App, Dashboard from Navatis to communicate with TAC2 EZ-GO RXV Controller, the green brick, it has Bluetooth.  The App is not very stable, I had to uninstall and reinstall to get it to work.  Just a reminder.  Don

Motor Control.jpg

DC to DC Converter 01 Loose Conn.jpg

TAC2 EZ GO RXV.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By rev6engines
      Black Friday is here, and we’re excited to give our offroad family 20% off on all parts and kits! Whether you're prepping for new trails or just fine-tuning your rig, we've got what you need to keep rolling. Now Is also a great time to upgrade your sled, winter's coming fast!
      If you have any questions or need help finding the right part, feel free to call, text, or email us. We’re here for you!
      Call or Text:
      801) 489-8697
      Email at:
      [email protected]
       
      Happy riding!!! 🤘

    • By dman66
      My buddy has a ut400 that the forward gear keeps popping out of gear. She only has like 400 miles on the odometer .the shift cable has been adjusted and the shift lever has been updated / modified. All other gears are good. Is there an internal detent cam or something that wears out or shift fork that can be replaced ? Or is there some other magic that I can perform ? Looks like the engine needs to be split.
    • By Texjpr
      2002 ranger 500 4x4 stopped running and wouldn't restart. Service manual wiring diagram helped identify the hub safety switch as the culprit. Using jumper wires to bypass  switch allowed the engine to start and run normally. Inspection of switch showed melted epoxy and a strong smell of burnt electrical. Unable to find replacement part either used or new. Is there a work around other than jumper wiring?
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By Chucky 1
      I purchased a new 2023 Landmaster UTV L4 in October of 2023.  UTV didn't seem to have as much power of the demo L4 that I drove but figured once it broke in it would be better.  After about a week the unit started bogging down backfiring and stopping.  Gas fumes really bad, wait a few minutes and it would start up again.  Brought it back to the dealer and after keeping it for a few weeks said he couldn't find anything wrong with it.  Got it back home and it started acting up again, brought it back to dealer a week later and he said he found couple things that might cause it to do run bad and he was able to replicate the issue but didn't really know what was wrong.  Got it back home again after being at dealer for several weeks and the unit started running bad again right away.  Brought it back to dealer and he went back and forth with Kohler about possible fixes but just checked somethings and try to swap a few parts but still runs bad.  I called Landmaster HQ to speak with someone about a refund and was told that was handled at the dealer level.  Dealer called Landmaster and they told him they didn't do refunds or exchanges especially with units that had problems.  The dealer is now trying to get a new engine to but I have not heard anything as of yet.  I did file complaint with Better Business Bureau and they accepted my claim and reached out to Landmaster.  The National Service Manager called me and said the he had been contacted by the BBB about the complaint and he would look into it.  I told him that I would just like to have my down payment of $2,000.00 returned and never mind the over $1,000.00 I have paid in notes for a UTV that I cannot even ride on without hoping it gets me around the neighborhood.  I have found out that the 2024 Landmaster UTVs will have Vanguard engines due to issues with the Kohler engines.  Very disappointed in what is "Proudly Made in the USA" and the way Landmaster has treated this disabled veteran! 
×
×
  • Create New...