Quantcast
Jump to content


Recommended Posts

Posted

My Coleman 400 UTV is about a yr old  started it up yesterday parked it outside..later on the day it would not start. Has gas, cranking trying to start but won`t turn over. looked at trouble shooting tips and it said check spark plug. Where is the sparkplug located and any other suggestions

Posted

You say cranking but won't turn over? Do you mean it won't fire, or it won't crank?

First check your battery voltage is about 12.5V, make sure you have fuel in the tank.

From there you can check for spark the spark plug is on the back of the motor under the bed. Connect an inline spark tester and make sure you have spark when cranking.

Then I would remove the fuel injector and verify fuel pulses when cranking.

If all that's good I would check the valve lash & timing.

  • 2 weeks later...
  • 7 months later...
Posted

 My Coleman runs and drives but it loses power when going up a hill is there anything that would cause this to happen? It won’t barely pull itself up hill it runs fine other than this issue.. please help 

Posted
On 7/18/2023 at 2:41 PM, Carrie said:

 My Coleman runs and drives but it loses power when going up a hill is there anything that would cause this to happen? It won’t barely pull itself up hill it runs fine other than this issue.. please help 

I just purchased a 2021 Coleman UT400 and had a similar problem. Now the manual states the grade should not be more than 15%. The hill on my property, and there is multiple ones, is probably around 35%, but I got it to get to the top, about 30 +/- feet or so. I did read in the manual that when going up hill, to put the UTV into 4WD for better traction. I have to try that to see if by having both axles pulling, the UTV will not struggle as much.

Information on climbing hills in my manual is on page 7-10.

I'll update, but give it a try and see if it helps.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Homeowner A
      I have a Coleman UTV 400 and looking for something to store it in.  Preferably something vinyl or plastic with its own base that can stand alone outside and house the UTV.  I think the dimensions of the UT400 are around 106" long 52" wide and 74" tall. 
      What should I consider that won't break the bank?    
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By Howard Elmore
      I have owned mine for a couple years now but newer took off road.  How well does it do trail riding m?
    • By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
    • By Will Sutton
      I've got a 2023 UT400 (bought from tractor supply) and I've been beating my head against a wall with it.
      It will start and idle perfectly. The second I touch the throttle it sputters and dies.
      I've checked that the fuel pump is working  (it is).
      I've replaced the injector, throttle position sensor, O2 sensor, and intake air sensor. All with no change.
       
      I've just taken a look a the schematic, and there is a crank position sensor as well.

      Could this be the source of my troubles? If so, where is this thing located? I can't seem to find it on any drawings from the parts suppliers.
×
×
  • Create New...