Quantcast
Jump to content


Coleman 550 2019 Engine/trans locked up. Lost oil out of the bottom.


Recommended Posts

Posted

I was riding at approx 30mph when I heard a very loud noise.  Engine immediately died and coasted roughly 50ft.  There was a trail of oil and now the machine is locked up.  Will not crank or go in to neutral.  Machine has 3300 miles. 

Posted

Sounds like you need to crawl under and take a look and see what's broken, where its leaking, etc. Unfortunately we can not do that for you over the internet.

Post a picture of where the oil is leaking from and we can help identify the issue.

  • 2 weeks later...
Posted

I have never seen a complete hisun engine sold aside from a few random one off sales on ebay.

Did you get a look and determine its dead? What exactly is wrong with it? There are certainly parts available depending on the exact issue. It you want to swap it anyway I would go ahead and remove it and try to figure out exactly what failed first.

Posted

Rod came thru the block.  It’s really bad. Side cover and lower section of engine have a large chunk knocked out.  There’s not internal parts that are usable.   A short block might work.    I found a 2018 complete but I am not sure it will work in the 2019.    I’m told 2016-2018 is different that 2019 and up. 

Posted

Not sure the exact year for cutoff on engine designs, i think the only major change is going from cabed to EFI. Not aware of any short blocks available. Unfortunately might be better off looking at a new SxS.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Jr Perez
      I need help when I put the key in and put to on position the neutral light turns on then shuts off I tried moving the shift linkage but the neutral light won't turn on it only has 651 miles cranks fine 2019 tboss 550
    • By JimG
      Recently, my unit Axis 500 (2020) will only go into reverse and neutral. I am not able to get high or low. The engine itself sounds fine and I do not have other issues on this unit. I change the engine oil but have not yet changed the gear oil.
      Before this happened I occasionally encountered issue where going from reverse to high gear, it would grind some and i had to reposition to shift into high gear. I also for last couple weeks heard a squeaking sound. I couldn't tell what it was. Was looking for a grease point I missed.
      The unit has around 70 hours and is kept in the garage.
      Anyone else encounter this type of scenario? Any suggestions on troubleshooting would be appreciated. Thanks.
    • By boydog40
      my subaru gave it up, bought a new Predator 670cc
      problems is, wiring the buggy to the new motor, OEM key switch has 5 wires (red, green, yellow, black and brown)
      new motor has many more wires than the Subaru and i have no idea what goes where!!!
      finding any info on the web is almost impossible to do also
      any help will be greatly appreciated!
      thanks guys
    • By Homeowner A
      Picked up an essentially new 2022 UT400 with 9 miles on it.  Decided to change the oil because it's probably never been done.  Pulled the dipstick and noticed it was overfull then went and pulled the drain plug and took off the filter and it was like brown water running out.  What should I start checking?
    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
×
×
  • Create New...