Quantcast
Jump to content


3 seater 60" max width - Searching for a UTV for general utility and some trails


Recommended Posts

Posted

We have 2.4 acres of forested mountain property with about 1000' of gravel driveway to plow and maintain.  My trailer is a Silverwing SW9f 5'x9' and we would really like to have something that seats 3 people.  I looked at Polaris, Yamaha, Can-AM, Kawasaki and so far the only thing that fits the bill is the Polaris Ranger 570 full size. 

Just wondering if anyone else has ideas of other options new or used that would fit this?  I really like my trailer and it will be great to use behind the UTV also when i get it so i hate to have to get something different.

Thank you!

Posted
34 minutes ago, Travis said:

Have you looked at a 4010 Trans? they have the fold down seats, so you can either have extra seating, or extra bed space.

I have not thanks for the suggestion.  I didnt see this on on their site when i looked.  

Posted

I had a Kaw Mule 2510, and now a 2011 TransMule 4010.  No problems, just routine maintance, I bird hunt on them - so they get used, I have had mine from ND to TX.  I really don't know the width.  On every reliability test, the Mule wins, but that is as much about the age of the user, as the machine.  Mine has a easily removed jump seat for 6 adult or 12 kids!

1109936982398044.jpg

Posted

58.2" wide.

Whatever you buy make sure it had fuel injection and power steering.  I think they are about what I paid 11 years - $11,000.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By tskm
      in desperate need of a rear differential for my 2014 wildcat 1000. It has blown up right in the midst of the hurricane that struck us here in N/W N.C. I could really use this machine right now. No luck finding this from Artic Cat or the many numerous online vendors. Any info or resources wil be greatly appreciated !
      Tom 
    • By Kingfish
      The conversion took about 350lbs. off the vehicle.  It never rode great, but now I feel every  crack in the road.  I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff.  I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order.  Does anyone have the data for the original spring compression rate?  I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
    • By Brett
      Fuel injected 700 starts great and idles great but touch the gas and it dies
    • By Jon Spruill
      Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
×
×
  • Create New...