Quantcast
Jump to content


Recommended Posts

Posted

I'm thinking about parting out my 2 Joyner's.  Both have less than 500 miles.   I would also consider selling whole.  I have titles for both and have owned them since new.   Located in northwest Florida.   I'll be in Gatlinburg , TN for Christmas if someone needs a heavy part delivered     Trooper engine has rust on the cylinders and probably won't turn over at this point due to Florida humidity.  The sand spider has a broken input shaft in the rear end, so it needs a new (cheap) input shaft and seal.   It hasn't been cranked in a couple years.  Both are complete.

Posted
14 hours ago, Buddy1113 said:

Im intersted in the joyner as well and live in florida near ocala 

There are 2 of them .  Be more specific......interested in what ?   A certain part / parts ?  Buying one or both whole ?    Not much to go on except your location.

Posted
50 minutes ago, STIHLMAN said:

I'm in Monroeville,Al. and I my want one or both of these units ,but need to look at them.

Not too far from me .   Been there a few times . Harper Lee was an old friend of mine :)     
 

you want to come look or pics ?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By JimG
      Recently, my unit Axis 500 (2020) will only go into reverse and neutral. I am not able to get high or low. The engine itself sounds fine and I do not have other issues on this unit. I change the engine oil but have not yet changed the gear oil.
      Before this happened I occasionally encountered issue where going from reverse to high gear, it would grind some and i had to reposition to shift into high gear. I also for last couple weeks heard a squeaking sound. I couldn't tell what it was. Was looking for a grease point I missed.
      The unit has around 70 hours and is kept in the garage.
      Anyone else encounter this type of scenario? Any suggestions on troubleshooting would be appreciated. Thanks.
    • By Jerrys500
      Hi I'm about to order parts to do a bunch of work on my Massimo. Does anyone know if there's a difference in the top end kit {piston, Cylinder, Rings, Gaskets, Piston Pin} if it has a carb or EFI? I'm EFI and I think some came with a carb so I thought i'd ask before making a mistake...
      Thanks Jerr
    • By Robby
      Hello, I have a 2013 500 utv hisun. Was running ok and cut out while parked. Bike will not start now. It turns over, but won't fire. I have no spark and no fuel. I replaced fuel pump, ignition coil, spark plug, cdi, voltage rectifier and all the fuses and relays. Could bad stater cause no fuel because I can't hear the fuel pump priming. Any info on where to start looking for problem.
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By Poppateets
      I just purchased a used 2023 Massimo warrior UTV SxS 1000mx with 600 miles on it. I didn't even get a full day of riding and the driver's side rear axle broke. I'm pretty sure it was already going bad because we would hear a noise once in a while. I'm wondering if anyone else has had problems with theirs. Also looking for places to buy accessories.
×
×
  • Create New...