Quantcast
Jump to content


Noise reduction on the 400...

Charles Hines

By Charles Hines
in Coleman UTV SxS Forum

 Share

Recommended Posts

Charles Hines Apprentice

Charles Hines

Posted
Posted

These Coleman 400's are LOUD, so loud I wear earplugs when cruising. With that in mind,I added a secondary Kolpin silencer to the stock muffler. It helped a bit but the thing that has helped the most is foam sound deadener. I added the foam deadener to the inside of the plastic front seat base,covering the whole surface. I also added a piece on the driver side plastic cover and the side of the gas tank facing the motor. I used standard acoustic foam known as eggcrate and contact cemented it in place. Very noticeable reduction in the noise from the engine and drivetrain. Much more enjoyable ride for just a few bucks.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Topics

    • Homeowner A
      Coleman UT 400 Garage?
      By Homeowner A
      I have a Coleman UTV 400 and looking for something to store it in.  Preferably something vinyl or plastic with its own base that can stand alone outside and house the UTV.  I think the dimensions of the UT400 are around 106" long 52" wide and 74" tall. 
      What should I consider that won't break the bank?    
    • Howard Elmore
      Coleman 550 trail riding
      By Howard Elmore
      I have owned mine for a couple years now but newer took off road.  How well does it do trail riding m?
    • Will Sutton
      Coleman UT400 won't rev. Idles fine
      By Will Sutton
      I've got a 2023 UT400 (bought from tractor supply) and I've been beating my head against a wall with it.
      It will start and idle perfectly. The second I touch the throttle it sputters and dies.
      I've checked that the fuel pump is working  (it is).
      I've replaced the injector, throttle position sensor, O2 sensor, and intake air sensor. All with no change.
       
      I've just taken a look a the schematic, and there is a crank position sensor as well.

      Could this be the source of my troubles? If so, where is this thing located? I can't seem to find it on any drawings from the parts suppliers.
    • dman66
      2018 Coleman UT400 Trans keeps popping out of forward
      By dman66
      My buddy has a ut400 that the forward gear keeps popping out of gear. She only has like 400 miles on the odometer .the shift cable has been adjusted and the shift lever has been updated / modified. All other gears are good. Is there an internal detent cam or something that wears out or shift fork that can be replaced ? Or is there some other magic that I can perform ? Looks like the engine needs to be split.
    • mark walkom
      sector e1 regen has stopped (mostly) working
      By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...