Quantcast
Jump to content


Recommended Posts

Posted

Still working on this darn roof so have not had a chance to work on the Trooper. SOOOO, I have had time to think about the upcoming repair OR should I replace the drivetrain with something with a lot more horsepower? IF you were going to replace the entire drivetrain, what would you replace it with, Honda, Subaru, ?? Also an Automatic trans would share be nice in the rocks like Moab!

Also Lenny or Kinarf, did one of you guys have a chance to calc the drive ratio on the diff when you had it a part? If a person was going to replace the drivetrain, it would be important to come close to the final output ratio of the existing trans.

Too quiet on here so something to chew on.

rocmoc n AZ/Mexico

Posted

Roc, if you are thinking of replacing the drivetrain and instilling a auto tranny, why not go the whole hog and replace the motor too. It would be a lot easier but would cost more. I'm not a fan of autos in a 4x4 but if that was the case or not, it would have to be a Subaru. Someone's got to do it one day.

If you muck around in the shed with that in mind you could end up with something like this.

But the engine would be in the back and have better off road ability.

Just a thought.

Cheers Mike.

Posted

Yes I met the WHOLE thing, motor & trans. We now in the Trooper have a car front wheel drive setup turned sideways. I had a similar setup in my SpecRacer Ford only the front wheel drive setup was installed in the rear for better handling. There are much more powerful stock engine & trans combs and would not cost more than a turbo. After reading the turbo thread, it would cost LESS!

rocmoc n AZ/Mexico

Posted

OMG, your right. On ebay there is a good range of motors at a good price. If you have already done a suspension upgrade, the extra weight of a bigger block will be OK. The Subaru's are AWD so will have to run through a transfer box I guess. What to watch out for is size, you know, will it go in the gap without to much dramas lining up the drive shafts (will that make the donor engine to high or low) and the wiring. Not a bad option at all.

Cheers Mike.

Posted

Roc, just thinking further with a donor engine & tranny for the Trooper and found out a Subaru engine could possible be to wide. That is a Boxer engine anyway. Although you do get a pretty good balanced engine and a low centre of gravity, at the end of the day she's a fat engine and the plugs are down low which can't be that great for river crossings. I have however come up with another possible engine. The wife's car is a Toyota Gita which I think you call it a Lexus IS300 over there which has a fantastic engine in it and it light. The bonus is, it is a AWD & the tranny is a 5 speed auto tiptronic (the best of both worlds). You would still need the transfer box I would think but I've done a quick measure up and yep she would go in with maybe the Rad. moved up onto the cargo bed. The max power is a crazy 220PS (217 BHP or 162 kw) @5800 rpm. That's more than enough from this lite aluminium block which has a power to weight fig. of 143 bhp/ton in the car. Don't get me wrong, I think the Trooper's powerplant is fine but it's fear to say, "it's got me licking my lips". The Lexus engine is the 2JZ-GE and here is what I mean and is for sale on ebay USA now for $1k. with an uncut wire harness, ECU and the Tranny.

http://cgi.ebay.com/ebaymotors/99-Lexus-SC...45#ht_806wt_938

Cheers Mike.

Posted

Here's an idea I saw on Youtube. A guy took a Honda front wheel drive and put it in a homemade tube buggy. He stuck it in sideways and used one side of the output shaft to the front diff and the other side to the rear diff. You would have to figure out a way to lock the tranny up so, it wouldn't shift from front to back under load like front wheel drives shift from one side to another.

Posted
Here's an idea I saw on Youtube. A guy took a Honda front wheel drive and put it in a homemade tube buggy. He stuck it in sideways and used one side of the output shaft to the front diff and the other side to the rear diff. You would have to figure out a way to lock the tranny up so, it wouldn't shift from front to back under load like front wheel drives shift from one side to another.

Good point, how to lock the tranny? Forgot about this little problem.

rocmoc n AZ/Mexico

Posted

The daughter has totalled her Saturn Ion twice and I have out it back together both times. If and when I get her another car, I will have a donor motor and drivetrain for something. Pipe buggys with old VW engines are big here in W.Va so I will pick me up a chassis and build something in a couple years from now.

Posted

Yeah and if a guy did get a car engine in it you could keep the accessory drive together and rig up power steering and use the A/C compressor as a air pump for flat tires and such. a honda engine seems like a good choice especially an inline 4 cyl should be an easy squeeze.

There seems to be lots of stores on ebay that sell motors. you can look through all the pics and see what on looks like it will work like this one http://cgi.ebay.ca/89-94-MAZDA-MX3-AUTOZAM...34.c0.m14.l1262

Its a Mazda but it has the same layout as the trooper

Posted

One problem is you really need a complete crashed car for the computer, wires & misc. parts. Roof on the house is complete, a little business trip for a week and finally will be able to do some work on the Trooper. I will have to make a decision by then.

rocmoc n AZ/Mexico

Posted

Been giving it some thought, I will repair the existing trans. I already have too many projects to be adding another large one. Also my calcs are that it would take between $1500 - $2000 to do the change over even if you were able to purchase a complete wrecked car for aprox $900. Again, too many existing projects calling out for the dollars. Something to do in the future! I do believe at this point since I don't play in the sand that often, I would rather have an auto trans for rock crawling. Boy am I getting lazy in my old age. There was a time I would not even considered a auto in anything. Now almost everything I have is an auto.

rocmoc n AZ/Mexico/New Mexico

  • 2 weeks later...
  • 5 years later...
Posted

Alright guys, I've been thinking about this for a year now and I think I'm going to try a 2000 model pontiac grand am 6cyl auto swap into my trooper. The grand am I used to own had an electrical switch that locked up both front wheels for traction when needed, I think this will give me the power I want and solve the issue of needing a transfer box. I think I might start this project in the fall of this year or next, I have too many irons in the fire right now but I believe this is the answer to an engine swap with more power and auto tranny.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By Kingfish
      The conversion took about 350lbs. off the vehicle.  It never rode great, but now I feel every  crack in the road.  I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff.  I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order.  Does anyone have the data for the original spring compression rate?  I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
    • By Clayton Walker
      After searching all summer, I finally found a company that makes a cargo rack and roof rack for the UForce XL, and I wanted to share it with fellow UForce owners. I know this is my first post, but I’m just trying to save others the time I spent researching. I bought one for hunting, and it works great, so hopefully, this helps anyone looking for a similar setup. 
       
       

    • By Fishing Wiskers
      Top speed is 30mph on flat grass ground.  but it will not go up minor hills forward or reverse without a runing start.  If you start at the bottom of the hill machine will stop about 1/2 way up.  I have the engine cover off and you can see the outside of the drive clutch will stop spining., and the engine does bogg down some.  Dosent matter if engine is cold or warmed up.  Seat belts are connected.  Fuel is clean
      I am the 5th shop to look at it and different shops have replaced the fuel pump, injector, ign coil, wet clutch, 
      I am not sure how to check for codes with this machine,  can anyone teall me how to do it?
       
      Compression with hot eng is 145,  valves adjusted to .005 with a cold engine.  Dash shows 426 hours
      I am not convinced it's an engine problem
×
×
  • Create New...