Quantcast
Jump to content


Massimo Buck 250 won't start - engine light on

BeachBuggy

By BeachBuggy
in Massimo UTV SxS Forum

 Share

Recommended Posts

BeachBuggy Newbie

BeachBuggy

Posted
Posted

Massimo Buck 250 less than a year old.  900 miles on it.  Live on beach in TX...i.e. corrosive salt air and normally mild temps.

The story - one day, it randomly quit on idle and was tough to restart.  Next day, it occasionally cut out for 1-2 seconds while driving, then catch back to normal throttle.  Pumped gas pedal, not sure if that helped it catch.  Added some marine sta-bil and filled tank.  Ran well after that for a day.  Following day, wouldn't start.  Turns over, cranks, but won't start.  When it quit on idle that was the first time driven since we did have a freeze of ~25 degrees.

Full charge on battery. No spark.  Changed plug and still no spark.  Fuses look good, but fuse connection box has some loose clasps and spade were corroded. I bent clasps best I could and used dielectric on spades re-inserted.  Cleaned and checked every connection I could find.  Don't have a card reader to hook up, but did swapped ECU just to check that, and no change...after swapping ECU the engine light now stays on.  Previously blinked and then goes away.

Under warranty but service place is 2 hrs away. 

thanks!

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Topics

    • Jim Kessell
      EH65 spitting fuel from breather hose into air filter.
      By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • Frank in MI
      New old guy
      By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • Jacob E freeman
      2018 cub cadet challenger 750 over heats no one knows why
      By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
    • Mark Anderhalt
      Massimo MSU 500 rebuild
      By Mark Anderhalt
      Question, Does anyone know if a 700-cylinder, piston, and head fit on top of a 500-bottom end, Although I have a 500 and have rebuilt the 500 once, I'm thinking the lower end may be the same for both the 500 and the 700. Does anyone have information on that?
    • felo72
      24 Massimo Buck 250 Parking Brake Issue
      By felo72
      Hello all. I purchased a brand new Massimo Buck 250 EFI in June for our farm and I've had the parking brake fail on me twice. I have approximately 250 miles on the vehicle. The first time was less than a month after receiving the UTV. We all of a sudden lost brake pressure and it would not start. I tracked the issue back to the parking brake. Upon removing the chain cover, I noticed the brake pad was missing and the caliper piston was touching the rotor. I found a set of brake pads online and replaced them myself. It's worked for several months and just happened again. Seems like a design flaw. I'm reaching out to see if there's an upgrade option available, or if I should replace the entire caliper with the brake pads? Thanks in advance for any advise.
      I submitted a warranty claim, so I'll keep this updated with what Massimo replies.
      When I replaced the brake pads the first time, back in July, my Son made a video on YouTube to show the unique caliper design. Here's a link if you wanted to check it out:
       


UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...