Quantcast
Jump to content


2021 Hisun Sector E1 Lithium Batteries

Curt Gray

By Curt Gray
in Hisun UTV SxS Forum

 Share

Recommended Posts

Curt Gray Newbie

Curt Gray

Posted
Posted

Sorry if this is on this site new to going on forums

 I have a 2021 hisun sector e1. I've seen people say they put lithium in can someone point me to what and how many lithium batteries to put on this bike. Thanks I notice up hill the low range says 400 amps on the dash.

  • Alex changed the title to 2021 Hisun Sector E1 Lithium Batteries
GNFO Explorer

GNFO

Posted
Posted

There's this thread, which I contributed to a few months ago:  

I replaced my Discovery batteries with four ReLion Insight 48V batteries, which have the same form factor as the old batteries.  I went with them because of that, but mostly because each battery has a max continuous output of 100A, so the four of them combined can match the full 400A capability of the motor.  Also their tech support was great and sent me the new charging profile and instructions so I could flash the existing onboard charger to change it over to their custom lithium battery charging profile.

The fact that you can still see 400A with your original batteries is interesting, since I was never able to see that and was at the point of the UTV slowing down and throwing error codes when hauling uphill.  The upgrade isn't cheap, so you may want to make sure you're at the point where you just can't squeeze out anything more from your old batteries.  That said, the performance improvement is great.  Four batteries is plenty of capacity for my use, but if you require maximum range (and don't mind the cost) you can actually parallel 8 of them and still save almost half the weight compared to the Discovery batteries.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • CapnWalleye
      2016 Hisun 500 runs rough no power
      By CapnWalleye
      Just picked up a Hisun 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • Gorj
      Sector E1 Battery change out
      By Gorj
      I am going to replace the batteries in my E1. I am not interested in the high cost Lithium or the expensive 6 volt dry batteries.  I am considering four 12 volt deep charge marine batteries. I have a source for 810 amp units for about $100 each.  I have no worries about reprograming the charger because it went out a few years ago and I replaced it with generic golf cart charger. When I decide to do this, I'll keep you posted on the results.
    • Homeowner A
      Code Reader for Delphi MT05 Coleman UTV 400 Hisun
      By Homeowner A
      Is there a code reader available for the Coleman UTV 400?  I tried using the HUD ECU Hacker software and cables/adapters but no luck OBD to delphi 6 pin and KKL VAG as well as ELM327.  Will not connect.  I was able to get it to connect randomly a couple of times, but haven't been able to since.  I was able to clear and read the codes briefly.  I'm aware of the Tiny Scan 301 but it doesn't seem to be readily available.  There's a few out there but they are expensive.  
    • Marie
      Wiring 2013 Hisun 800
      By Marie
      hello, i need help figuring out where all these wires go on this battery. I can't seem to find any pictures diagrams. As to what should or shouldn't be attached and where these two plugs go, that aren't plugged in. this was got as a project. would run then die and battery would have to be jumped off to start again stator has now been replaced but any help with this wiring would be appreciated. 
    • Marie
      2013 Hisun 800 Please Help Wiring
      By Marie
      Hello, we recently got a 2013 Hisun 800 as a little project for my husband and I to work on. Turns out the guys before us loved the mud anyway. We have replaced the stator and now going to do the Rectifier but here is the hold up as seen in the picture. There are tons of wires going to the battery. I cant seem to find anything that shows what wires should, or shouldn't be attached to the battery or where these 2 plugs go. if someone would please take some pics or share knowledge to where they go I would appreciate it greatly.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...