Quantcast
Jump to content


New Dealer in Las Vegas

Paiute3

By Paiute3
in Joyner UTV SxS Forum

 Share

Recommended Posts

Paiute3 Proficient

Paiute3

Posted
Posted

We finally have a REAL dealer in Las Vegas! Bad Ass Golf Carts is our new Joyner dealer. We took the T4 in and they were AWESOME! Very knowledgeable and the repair was quick.

They are located off of Las Vegas Blvd and Sunset.

I've invited them to come and join us on the forum.

Cinda

Guest Lenny

Guest Lenny

Posted
Posted
We finally have a REAL dealer in Las Vegas! Bad Ass Golf Carts is our new Joyner dealer. We took the T4 in and they were AWESOME! Very knowledgeable and the repair was quick.

They are located off of Las Vegas Blvd and Sunset.

I've invited them to come and join us on the forum.

Cinda

Keep up the good work Cinda.

Lenny

brostar Proficient

brostar

Posted
Posted

Bad Ass Golf Carts, I just love that name. Had a look on their website and his golf carts are indeed "Bad Ass". Cinda with his fibreglass fabrication skills he would be the man to come up with a new design for the front guards to keep mud and sand contained. For those of you that have gone to the larger diameter wheels, the rear guards need to be set higher too.

Cheers Mike.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • staind
      Joyner R2 2008 800cc ECM code reader Lite or OBD port install
      By staind
      Looking for information on installing a OBD port or a lite to read codes in ECM. 
      I can not find a OBD port or a lite to read codes on this R2 with 800cc. 
      I have code readers and adapters for most ATV's. From what I've found so far. They don't have a connection for to read codes. I may be wrong. That's why I'm asking. 
      This R2 has had new IAC, TPS, MAP, fuel pressure regulator and fuel pump replaced. This was done by neighbor to try to stop surging. It still surges on start up and then settles down. But once you hit the accelerator it revs up to 2000+ rpm and stays till you block off IAC port in throttle body with finger. Once you do that it once again settles down and idles perfectly.
      I want to know what the ECM is reading to help dio it.
      This joyner is the first one I've run across. Well second one in a week. (my neighbors 2 of them) The other was a trooper with the 1100cc chery motor that had been setting for years. After cleaning up the fuse box connections. It runs like a top. Had to replace all gages with aftermarket gages. Water, oil, gas, amp. Only problem one was the water temp using original sending unit. Had to install 150 ohm resistor on the input wire to get it to read correctly + - 5 degrees. Close enough. Gas sending unit was/is for a boat tank 6" tall. All SS so it should last forever. 
      thanks Dan D. aka staind
    • Roadstar515
      2022 Hisun 750 EPS Overall very loud while driving
      By Roadstar515
      Just wondering if mine is the only one that’s seems very loud while driving. It just seems louder that other brands I’m use to. I guess you get what you pay for I’m assuming.
      Regards, Rick
    • Prepper
      New member from Eastern Kentucky
      By Prepper
      Hello All...
           Just bought a 2014 Massimo 500 UTV.  It;s not running at the moment, but hopefully will soon.  I need a seat for it also (passenger side, if it makes any difference.)  It is a crank-but no start situation.  Just now starting to read the boards for solutions.  Apparently these models are well known for this issue.  If anyone has any suggestions, please feel free to chime in, it would be greatly appreciated.
      Thanks 
    • Tarak1980
      New member From Northern Indiana . and coolant ??????
      By Tarak1980
      I have a Coleman HS400UTV-5 got it manly for hunting and spending time with the grandkids
      The one problem I am trying to avoid. My son borrowed it last summer and said it ran hot so he added water to it . I do not know how much he put in so I would like to drain most of it and add new coolant to protect it this winter. I can find no drain cock or any way of draining it besides loosening a hose.  Any suggestions ????
    • Clayton Walker
      Im New here but just got my Uforce Fitted for Hunting Season
      By Clayton Walker

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...