Quantcast
Jump to content


Recommended Posts

Posted

I purchased this side by side with the following done to it
3" Outkast Lift
6" 45% GDP Portals
22" Msa Rims
9.5/22 (40") Tr-171 BKT
Rhino 2.0 All The Way Around
Dirt Mafia Upper and Lower Ball Joints
Brass Brake Pads
Superatv Front Trac Bars
2 6.5 Kicker Speakers In The Dash
High Lifter Snorkel Kit
Highlighter Front 3" Lift
I recently had turf mode deleted along with snorkel and pinion gear, gear reduction and new bearing and seals.. I keep breaking rhino 2.0's in the rear on the differential side. I purchased the side by side without the trans work done and didn't have many rides done on it before I had the work done. Could it be something the mechanic had done when completing turf mod delete? I dont ride hard at all. Any input would be great thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By NC4wd
      Has anyone found a lift kit that fits an Axis 500? Mine is a 2021.
    • By shawn b
      my hisun died on me while driving it started losing power then stalled. it wants to start but wont . it didn't over heat. I replaced plug,fuel filter injector, and fuel pump.put code reader on it and says no codes. have any ideas possibly sensor? Any input on what it could be would be appreciated
    • By PossumTruck
      Greetings,
      I have a client that wants me to install a heater of some sort to aid in cold weather starting (she uses it at her business, has had issues starting the last few days in sub-zero). I would prefer a coolant heater to a pan heater (silicone pad), but I cant for the life of me find the diameter of the coolant hoses. Heck, I'm not even sure if it would work as well in this application given how long the hose is compared to tractors and trucks I have installed them in. 
      Any advice you could give me would be GREATLY appreciated. 
    • By Paul in Wisconsin
      I have a 2023 Tracker 800SX LE that I want to add a sway bar to.
      The service manual shows how to remove and reinstall the sway bar.
      I called Cabela's to try and get the saw bar.   They said they can't get one and the 800SX doesn't have one!!??  Then why is it listed in the service manual?? No answer from them.
      Have any of you found a saw bar that fits and what did it cost?
    • By Kingfish
      The conversion took about 350lbs. off the vehicle.  It never rode great, but now I feel every  crack in the road.  I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff.  I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order.  Does anyone have the data for the original spring compression rate?  I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
×
×
  • Create New...