Quantcast
Jump to content


Recommended Posts

Posted

After reading as much as I've found, I'm leaning towards a Renegade. I want to be able to put a bench seat in the back for part of the time, and be able to carry a deer , and a tree stand, fire wood etc. Do the Renegades have all the improvements that the Trooper got, and are the 2010 line out yet? What will be the difference between the 09 and 2010? I think for half play trail riding, and half work the Renegade might be better. Can you get the Renegade with power steering or do you put it on yourself. Does anybody know a good dealer near Maryland or Delaware that stock Renegades so I could try one. I don't mind driving a few hours if necessary. Thanks :)

Posted

The Renegade is a very capable machine which is a better commercial option than the Trooper and is almost as good as the Trooper when buying for recreational use. The Trooper's wider and longer wheel base, lower centre of gravity and more power will edge out the Renegade on the trails but with the Renegades huge tray and powerful 812cc you get the best of both worlds. Great choice. The Renegades running gear has had the same overhaul as the Troopers and the 2010 model is out now but not in all stores. Not completely sure of all the differences but I'd say the new axles, new design panel on the hood above the battery is flat which lets you know it's not old stock and I think like the Trooper the 4wd/2wd is cable operated (could be wrong). The big dealers have all the extra add-ons so yes you can buy the powersteering unit and get it instilled by them like this one here http://www.tobefast.com/joyner-renegade-po...r-10000258.html . Three good dealers with lots of extras for Troopers, Renegades and Commandos are McCoy Motorsports, No Limits Powersports and Silverbullet Motorsports.

There are no dealers in Delaware but in Maryland there is two. Fun on Wheels in Frederick 301-696-1911 and Kidnme Motorsports in Whiteford 717-825-0669. The nearest large Joyner Dealer that has a good reputation is McCoy Motorsports in Pikeville Kentucky www.tobefast.com . Their banner should appear up above this thread.

Cheers Mike.

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
    • By TPlummer
      We recently purchased the Axis x550. Fueled it with 93 fuel and drove one time around the farm and the 02 fault error appeared. Any ideas? 
    • By Kingfish
      The conversion took about 350lbs. off the vehicle.  It never rode great, but now I feel every  crack in the road.  I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff.  I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order.  Does anyone have the data for the original spring compression rate?  I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
    • By Woody77
      UTV MASSIMOREPLACED STATOR WANT start replaced rectifier still want start stator ohms out 5 ohms each leg what could be wrong at this point 
    • By Jon Spruill
      Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
×
×
  • Create New...