Quantcast
Jump to content


Recommended Posts

Posted

I have a 2014 landmaster S/S 4x4 model 653 4x4 with a 22 hp robins engine. I've been having problems with the govenor reving after it running a short distance. I cleaned the carb and discovered the fuel membrane has a slight pin hole (P/N 210-253). Can not seem to locate a replacement. Any suggestions? It appears this carburetor is no longer supported.

  • 2 weeks later...
Posted
On 4/21/2024 at 8:23 PM, Clyde says said:

280-62358-08.

Clyde, are you aware that number is for a propane carb. Are you trying to run it on gas? That carb is available for around 300.-00. If you were noty aware that it was propane powered, I would be trying to get a refundGood luckYou may be able to switch it to gas but thats not my forte. Oh, I saw the part available on partstree and a coupla other sites (ebay)

Posted

Thanks for the info. I did locate the part on partstree and it was very expensive $291.00 plus tax and shipping total $325. The part wasn't much bigger than a quarter. I'll try and include a Pic. Anyway I installed it and the UTV runs well. Yes it is gas not propane. I switched to non-ethonal gas.

 

20240427_091504.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By tskm
      in desperate need of a rear differential for my 2014 wildcat 1000. It has blown up right in the midst of the hurricane that struck us here in N/W N.C. I could really use this machine right now. No luck finding this from Artic Cat or the many numerous online vendors. Any info or resources wil be greatly appreciated !
      Tom 
    • By TPlummer
      We recently purchased the Axis x550. Fueled it with 93 fuel and drove one time around the farm and the 02 fault error appeared. Any ideas? 
×
×
  • Create New...