Quantcast
Jump to content


Recommended Posts

Posted

This 2007 YAMAHA RHINO 450 4X4 "CAMO" EDITION - Asking price: $2800 is in excellent cosmetic and working condition. RUNS GREAT, LOOKS EVEN BETTER, HAS SIDE DOORS, GREAT COLOR COMBINATION. Very clean. Mint condition with no scratches. It currently has 40 hours and 344 miles. I'm the original owner. It has been well taken care of and garaged kept. For more information and photos e-mail me at [email protected]

post-579-127085994314_thumb.jpg

post-579-12708599535_thumb.jpg

post-579-127085996034_thumb.jpg

post-579-127085996861_thumb.jpg

Posted

This 2007 YAMAHA RHINO 450 4X4 "CAMO" EDITION - Asking price: $2800 is in excellent cosmetic and working condition. RUNS GREAT, LOOKS EVEN BETTER, HAS SIDE DOORS, GREAT COLOR COMBINATION. Very clean. Mint condition with no scratches. It currently has 40 hours and 344 miles. I'm the original owner. It has been well taken care of and garaged kept. For more information and photos e-mail me at [email protected]

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By shawn b
      my hisun died on me while driving it started losing power then stalled. it wants to start but wont . it didn't over heat. I replaced plug,fuel filter injector, and fuel pump.put code reader on it and says no codes. have any ideas possibly sensor? Any input on what it could be would be appreciated
    • By Brett
      Fuel injected 700 starts great and idles great but touch the gas and it dies
    • By Fishing Wiskers
      Top speed is 30mph on flat grass ground.  but it will not go up minor hills forward or reverse without a runing start.  If you start at the bottom of the hill machine will stop about 1/2 way up.  I have the engine cover off and you can see the outside of the drive clutch will stop spining., and the engine does bogg down some.  Dosent matter if engine is cold or warmed up.  Seat belts are connected.  Fuel is clean
      I am the 5th shop to look at it and different shops have replaced the fuel pump, injector, ign coil, wet clutch, 
      I am not sure how to check for codes with this machine,  can anyone teall me how to do it?
       
      Compression with hot eng is 145,  valves adjusted to .005 with a cold engine.  Dash shows 426 hours
      I am not convinced it's an engine problem
×
×
  • Create New...