Quantcast
Jump to content


Recommended Posts

Posted

This gator has 62 hours on it and I am the original owner. This machine is loaded with custom JD wheels,

Hydraulic bed lift, front & side brush guards, front receiver hitch, JD stainless steel performance exhaust,

rear tail lights, JD OEM full windshield, full storage cover and matching Real Hardwoods poly top.

For more information and photos e-mail me at [email protected]

post-717-064637800 1286308435_thumb.jpg

post-717-068366200 1286308642_thumb.jpg

post-717-017502500 1286308903_thumb.jpg

post-717-033372600 1286309002_thumb.jpg

Posted

This gator has 62 hours on it and I am the original owner. This machine is loaded with custom JD wheels,

Hydraulic bed lift, front & side brush guards, front receiver hitch, JD stainless steel performance exhaust,

rear tail lights, JD OEM full windshield, full storage cover and matching Real Hardwoods poly top.

For more information and photos e-mail me at [email protected]

Why are you selling this?

  • 11 months later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Poppateets
      I just purchased a used 2023 Massimo warrior UTV SxS 1000mx with 600 miles on it. I didn't even get a full day of riding and the driver's side rear axle broke. I'm pretty sure it was already going bad because we would hear a noise once in a while. I'm wondering if anyone else has had problems with theirs. Also looking for places to buy accessories.
    • By KimAC
      I need a pair of front shocks for a Landpride Treker 4200NT, from 2005?  Does anyone know of a good salvage yard - or another source?
      The old shocks have "SEBAC 11685 12 3" stamped on them (or something very close - it's hard to read). I think SEBAC are (were?) an Italian company.
      Is there a compatible shock I can use? I don't have easy access to a scrap yard where I can compare shocks etc.
      Thanks,
      -Kim
    • By NC4wd
      Has anyone found a lift kit that fits an Axis 500? Mine is a 2021.
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By shawn b
      my hisun died on me while driving it started losing power then stalled. it wants to start but wont . it didn't over heat. I replaced plug,fuel filter injector, and fuel pump.put code reader on it and says no codes. have any ideas possibly sensor? Any input on what it could be would be appreciated
×
×
  • Create New...