Quantcast
Jump to content


Advice

charlie

By charlie
in Joyner UTV SxS Forum

 Share

Recommended Posts

charlie Experienced

charlie

Posted
Posted

Hey everyone. I got some questions any tricks out there for cheap suspension improvements on the trooper I know the factory tires suck and Im working on that. My shocks are set from the dealer setting.

My next question is has any one heard of the Roketa buggies specific the 800cc. My brother is looking to buy one I tried talking him into the troopers but its a little pricy for him. I dont want him to buy a piece of junk anythoughts or comments would help.

Any one using the fuel programmers from silver bullet motorsports I have one in my trooper no mods done except snorkle, and NGK plugs and synthetic oil. I have left my programmer at the factory setting thats what they said to do at silver bullets. So far I am happy but just wondering what any one else is doing. Thanx

  • 3 weeks later...
66fastcarss Contributor

66fastcarss

Posted
Posted

Hey everyone. I got some questions any tricks out there for cheap suspension improvements on the trooper I know the factory tires suck and Im working on that. My shocks are set from the dealer setting.

My next question is has any one heard of the Roketa buggies specific the 800cc. My brother is looking to buy one I tried talking him into the troopers but its a little pricy for him. I dont want him to buy a piece of junk anythoughts or comments would help.

Any one using the fuel programmers from silver bullet motorsports I have one in my trooper no mods done except snorkle, and NGK plugs and synthetic oil. I have left my programmer at the factory setting thats what they said to do at silver bullets. So far I am happy but just wondering what any one else is doing. Thanx

You probably want to post in the Joyner section of this board. That is where everyone hangs out and you will actually get an answer to your questions.

Jeff

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • A P
      2022 Hisun Sector 550 eps. Power steering not working
      By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • clint501
      Hisun E1 charger not working
      By clint501
      I recently purchased a Hisun E1 and the other day the charger stopped working properly. The LED on the dash blinks red & green and the light on the side of the charger also blinks red & green. The fan on the charger does not come on like it used to do. There is no error code that I can see. Does anyone have any suggestions to remedy this?
    • didgeridoo
      Hisun Sector e1 Battery replacement: any tips?
      By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • lincolnsq175
      Are there any performance parts for ut400?
      By lincolnsq175
      Ive searched and cannot find any performance parts that fit my machine.
      I have a 2020 coleman ut400.
      Im looking for machined sheave kit, programmers, cdi, exhaust and intake.
      I know these are yamaha rhino clones but are they rhino 450 clones?
       
      Any info is appreciated.
    • CRV
      Need some help. Looking for some parts too
      By CRV
      Howdy new member here . My hobby's Rabbit dogs , gamefowl . I'm retired from my real job but I stay busy with the hounds and gamefowl . So to help around the farm I ran across an old 2007 CC Big Country 4x2 to haul feed , water , sprayer and my sorry a$$ .It is in pretty good shape , 781 hrs. good plastic , tires, ect. . But as anything outside and 18 years old it needs seats ! The thing I have found wrong mechically the Diff. Lock Acturtor is broken where it mounts to the bracket ( partly why Im here ) . Hoping someone here can help  ! Just my wish list but Id like to find a roll cage and a composit/plastic top for it Im thinking I'll need a donor to salvage these things from ( again partly why Im here ) .Is there another brand that uses this same actuator? If anyone reads this and has or knows of any of threse parts PLEASE HOLLER !! 
      Again Howdy brothers & sisters

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...