Quantcast
Jump to content


Recommended Posts

Posted

I met Kinarfi (Jeff) and his wife for the first time on the way to Moab. I dropped off a parking brake master cylinder and talked Troopers for about 45 min. Jeff and Linda later met me down at Moab and literally made my day because I desperately needed a pair of snap ring pliers as I layed under my trooper's rear CV shaft. I heard a vehicle pull up...and there was Jeff! They are a remarkable couple and we really had a great time with them out on the trails.

I found out at Kanes Creek (before Jeff had arrived in Moab) that I had lowered my diff about an inch too much. At full droop it was popping the retaining clip out and dislocating. Of course this happened at the very bottom of Kanes Creek and I had to ascent two difficult climbs in 3 wheel drive. I will not confirm or deny that I had to be pulled a couple of times by a RZR 4...I will note, that just before my CV pulled out my buddy in his RZR 4 was complaining about powerloss and engine surge when he drove through the water. I legged my trooper back to the trailer and repaired it at camp. If it weren't for us having a front locker I would have been in serious trouble. I beat the ever-living hell out of both the front & rear ends making 5000 plus RPM's through some of the obsticals--they held strong. I think this is when I bent my front steering box fork, but I didn't notice it until I returned home.

So, after repairing the CV I met Jeff & Linda at Poison Spyder. I popped my CV out in the sand but with Jeff's help was able to get it back in quickly. I did several steep walls with ease while large Jeeps stood by and watched. One wall a Jeep attempted and backed away, one of the other walls a fully locked Jeep rolled over on trying to attemp (that is the attached picture). Neither of those were the steepest wall I climbed. The steepest wall I actually had the front wheels in the air as I crested the top. That one scared me a bit. Jeffs Trooper ran solid the whole trail; however, his body did have a few spyder bites afterwards. His suffered from a little less ground clearance, but he was able to power through everything.

The last day we chose an easier & more scenic ride. We did 7 Mile Rim. It was a great way to end the trip for me, but Jeff & Linda stayed a day or two longer. I can't wait to hear the rest of his trip report.

post-867-0-43032500-1338393758_thumb.jpg

post-867-0-90556900-1338393822_thumb.jpg

Posted

60-80 degrees I would guess. Maybe even lower in the middle of the night. Ironically, Sunday there was no wind and it was sunny and it was the coolest day I was there. it was around 65-75 degrees.

Posted

Yea, like 2scoops said, the temp was nice when the wind was blowing 2298834460104110397TNUAUo_th.jpg and cool when it was calm. We had plenty of slick rock, enough to last me for a while and plenty of sand. On the way home I stopped at a place called Woodside (ghost gas station, don't know if it was ever big enough to be called a ghost town) about 21.5 miles up hi way 6 from I-70 and headed off up CR129 and a short ways in saw 11 animals cross the road 2737299270104110397uCWqYo_th.jpg then stopped again at White River for a couple of nights before coming home to clean up.

A good Memorial Day week end +

Kinarfi

http://good-times.we...582893800ShfFQc

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By felo72
      Hello all. I purchased a brand new Massimo Buck 250 EFI in June for our farm and I've had the parking brake fail on me twice. I have approximately 250 miles on the vehicle. The first time was less than a month after receiving the UTV. We all of a sudden lost brake pressure and it would not start. I tracked the issue back to the parking brake. Upon removing the chain cover, I noticed the brake pad was missing and the caliper piston was touching the rotor. I found a set of brake pads online and replaced them myself. It's worked for several months and just happened again. Seems like a design flaw. I'm reaching out to see if there's an upgrade option available, or if I should replace the entire caliper with the brake pads? Thanks in advance for any advise.
      I submitted a warranty claim, so I'll keep this updated with what Massimo replies.
      When I replaced the brake pads the first time, back in July, my Son made a video on YouTube to show the unique caliper design. Here's a link if you wanted to check it out:
       


    • By Chas
      When traveling in the 40 mph range and throttle is released machine starts surging instead of a gradual slow down any help would be appreciated as dealer is clueless 
    • By Michigan sport.
      I'm sure many of you are aware of Michigan's emergency brake requirement.  I'm wondering if anyone has a good solution. 
      Beyond paying the few fab places $$$$.. I'm curious is there another rear caliper with e brake style that would interchange with slight mods to  the Maverick sport rear mounting bracket?
    • By Farid
      Hey there,
      I’m trying to find a CVT (variator) for my Tracker Off Road 800SX Crew. Do you happen to have one, or know where I can get it?
      Also, if you’ve got any other parts for this model, I’d love to hear about them!
      Thanks a lot!
    • By Alex
      This is an interesting read. ADAS is main stream on cars these days. The technology looks to be headed towards UTVs and Off-Road Vehicles.
      Potential Motors and CFMOTO USA have announced a new partnership to integrate advanced driver-assist systems (ADAS) into recreational off-road vehicles for the first time.
      Sam Poirier, CEO and co-founder at Potential Motors, says the integration of its technology into CFMOTO’s vehicles will set new standards in the side-by-side segment. (Photo: Potential Motors Inc.) The partnership will first see Potential’s tech integrated into CFMOTO test vehicles. The companies will conduct extensive real-world testing at Potential’s purpose-built off-road proving ground in Fredericton, Canada, and CFMOTO facilities.
      Source: https://powersportsbusiness.com/top-stories/2023/12/19/cfmoto-and-potential-motors-announce-industry-first-adas-technology-for-ohvs/
×
×
  • Create New...