Quantcast
Jump to content


Recommended Posts

  • Replies 38
  • Created
  • Last Reply

Top Posters In This Topic

Posted

2030914850104282158ZqXxTd_th.jpg

When I added my surge tank, I moved the fuel pump up next to the filter and also moved the pressure regulator, I also opened the gauge of the regulator and cleaned the dust out and then sealed it when I put it back together.

The gas tank has 2 outlets at the rear of the tank, if you are headed down a steep hill with just a half tank of gas, the outlets will be above the gas and the fuel pump will promptly be starved for gas and the pressure will drop and the engine will die. The lower the gas level, the less the steepness of the hill required for this to happen. A SURGE tank is a small tank the that is used to feed the fuel pump so this does not happen, mine has a low pressure pump to keep it full and the return from the regulator returns to the surge tank. This is an idea that was borrowed from snow mobiles.

Kinarfi

Posted

Never checked it....Turned it down and it was fixed lol...Something is not correct cause I wouldn't think you should be able to change how much injectors spray with fuel pressure.... And also the purge tank sounds like a great idea...Gotta look that one up on how yo do that...

Posted

Never checked it....Turned it down and it was fixed lol...Something is not correct cause I wouldn't think you should be able to change how much injectors spray with fuel pressure.... And also the purge tank sounds like a great idea...Gotta look that one up on how yo do that...

The higher the fuel pressure, the higher the volume of fuel that goes to the engine. The injectors are open for a specific time. At higher fuel pressure, more fuel can get thru in that same amount of time. The computer attempts to adjust it based on the O2 sensor output, unless its not hooked up, but it is still limited to how much it can adjust. Most everyone on this forum runs generally from 50 to 60 pounds fuel pressure. I'm not sure that the injectors will run properly at 30 psi. They do have a min and a max pessure they need to run properly. At low pressure, they don't atomize the fuel correctly and at higher pressure, the computer can't control the volume because injector output becomes somewhat earatic at above about 75 psi. You may want to try another fuel gauge. When mine was stock, it wouldn't even run below about 40psi. Kinarfis solution for running out of gas uses a storage reservoir tank, called as surge tank, that is kept always above a specific level so the fuel pump always has a fuel supply. I did the same thing by using a sump in the bottom of my tank. The sump also acts like as a storage reservior or surge tank. The idea is to create a reliable source of fuel when the Tropper is on a slope. There are a variety of ways to correct this issue. Some are more complex then others. I use an accumulator for smoothing out or eliminating surges in my fuel pressure.

Lenny

Posted

The higher the fuel pressure, the higher the volume of fuel that goes to the engine. The injectors are open for a specific time. At higher fuel pressure, more fuel can get thru in that same amount of time. The computer attempts to adjust it based on the O2 sensor output, unless its not hooked up, but it is still limited to how much it can adjust. Most everyone on this forum runs generally from 50 to 60 pounds fuel pressure. I'm not sure that the injectors will run properly at 30 psi. They do have a min and a max pessure they need to run properly. At low pressure, they don't atomize the fuel correctly and at higher pressure, the computer can't control the volume because injector output becomes somewhat earatic at above about 75 psi. You may want to try another fuel gauge. When mine was stock, it wouldn't even run below about 40psi. Kinarfis solution for running out of gas uses a storage reservoir tank, called as surge tank, that is kept always above a specific level so the fuel pump always has a fuel supply. I did the same thing by using a sump in the bottom of my tank. The sump also acts like as a storage reservior or surge tank. The idea is to create a reliable source of fuel when the Tropper is on a slope. There are a variety of ways to correct this issue. Some are more complex then others. I use an accumulator for smoothing out or eliminating surges in my fuel pressure.

Lenny

I will Have to check mine...Seems like it is running correctly and smells fine...Not to rich..I think I will pull the plugs and see what they are.....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Hunterman22
      2021 Hisun Axis 500 UTV (From Lowes)
      Will NOT START
      MY apologies if this is to much info just wanted to give yal the most information possible for help.
      I'm a so called diyer. An Electrician by trade 21yrs. I got my S×S from my last job. The contractor purchased this S×S for this specific job brand new, from Lowes. They used it for hauling materials, tools, & a little bit of anything you can think of on an Industrial type job site. 
      I remember getting on the SxS one time & pushed the gas petal all the way to the floor & SxS had very little power. 
      So anyway ,when the job finished up back mid July this year (7/2024) , I asked the contractor what they was going to do with it. I was told to take it. Otherwise it would go to the contractors yard (storage yard) & most likely rust away. 
      Took it home washed it , it had a heavy coat of dust on it & in it dust was every where. My helper & I had to push it on the trailer to get it home.  After washing it throughly I let it sit & dry out for a good day and half, maybe 2 days. Before trying to start it. NO START. Will turn over & try to start but thats it. 
      So here's what I've purchased & installed. New Air Filter, new spark plug, new air idle control valve (AICV), new throttle position sensor, new throttle body, new oxygen sensor, new digital dash speedometer/fuel gauge/clock. 
      Also drained the old oil & gas & replaced with new oil & 93oct. gas. I should probably mention that I've changed the AICV twice. The 1st time I changed the AICV I was able to get the SxS started & let idle for at least 10-15min. Drove out of the garage, with very little power,  turned it around & barely got it back in the garage.That was the one & only time I've been able to start the SxS. I've also cleaned the Throttle Body and & intake with TB cleaner.  So after that the AICV was  making weird noise so I pulled it out & tried cleaning it, pretty sure I messed it up. So I purchased a Throttle Body that came with new AICV & TPS. Still NO START.  I've checked the fuel pump & the fuel injector.  I took the injector off still hooked up to wiring & turned the key over, the injector sprayed a lot of gas out kinda the size of a volleyball. I've also checked the clearance gap on the intake & exhaust valve. But today 11/2/2024 I'm going recheck spark plug gap & the valve gaps. And alot of other checking. Would the driver side seat belt have anything to do with it not starting?? I know the driver side seat belt has to be in gauged for full throttle "going fast". Thing is the drv. side seat belt will latch but feels like might be messed up inside of it. Tired opening it up but to no avail.  I've never had a S×S or 4wheeler so I was really excited when I got the S×S,not so much anymore.  I work on & fix my own vehicles usually no problems.  But this SxS is kicking my ass.
      So if possible & someone could help me with some ideas or tell me what Im doing wrong or did wrong, I would greatly appreciate it.  Thank you for reading thus far.
       
       
    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
    • By TPlummer
      We recently purchased the Axis x550. Fueled it with 93 fuel and drove one time around the farm and the 02 fault error appeared. Any ideas? 
    • By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!



×
×
  • Create New...