-
Similar Topics
-
By Qtband
I'm looking at picking up this UTV and this is what the owner says:
"All I know about it is it runs. Display does not work and it will not move! Front end or trans could be locked up. It moves some, but does not sound good."
My question is, what could the moving issue be, and how can I check it out when I look at it? I feel the price is right at $2000, but I'd like to know what I'm getting into.
-
By Greg Kilgore
Was at Lowe's over the weekend. The wife and I seen they have a new Axis 550. That thing is sharp. Has a complete door. Speakers in door. Bigger engine. Bench seats. New styling all the way around. Looks to be more air tight than my 2022 model. I really like the looks but $10k is out of my price range for now. Unless I could sell mine. And the resale on the Axis 500 is nothing.
Went to the local wally world today. See a 4 person Polaris General 1000 on the back of a trailer. That Polaris looked exactly like a stretched version of the Axis 550. Even down to the vents in the windshield.
Just wondering if anyone can confirm or deny the Axis 550 is a copy of the Polaris?
-
By Ronald
Check engine light comes on after engine runs continuously for 5 minutes or so. I can shut down the engine and restart and check engine light goes out, then comes back on after running 5 minutes or so? What ya think?
-
By Alien10
A while back I was looking at an auction UTV plow and the mounting of it. Looked like it had an "H" bar with two pins that hooked into brackets on the front frame of the UTV. I have a bunch of 1/4" x2" angle iron, and some 2"x1/2" flat stock in the barn. I was thinking of welding up a bolt on implement mount that would provide 2 holes about 14" apart, that pins could be used to hook up an "H" frame for a plow or even a straight bar across with pins to hold it in place. The angle iron "A" would utilize the existing bumper mounting bolts front and bottom, and have the two channels "B" with holes for individual pins or one large bar across. Those channels would be welded to the ends of the angle iron.
Anyone ever try this for a front mount? It would be close to this one that is for sale on the net. It is supposed to fit a KFI plow mount.
-
By sxr951
2015 massimo 700.. need cylinder bolt! it some special cut from factory,, its a 125 thread but its like between 8 and 10 mm dont know where to find any ideas? thx
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.