Quantcast
Jump to content


Recommended Posts

Posted

New UK member here. Can anyone give me any help or advise on the Primary clutch on an old KAF450 Mule? The clutch has a lot of play in it and clonks alot because of this. Are these clutches serviceable and if so where can I buy the parts, or do I have to replace the clutch? I have seen a second hand one on ebay in the States, but they are asking more than what the Mule is worth!!! lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By FDWT9956
      I am putting a new primary and secondary clutch into a 2021 Sector 750. It is rarely used, only 350 miles, brought brand new and lost the CVT belt and I can't figure out why. In the first picture is the primary I removed.

      I received the new primary and it has a retaining ring around the outer edge. Does this make a difference?

       
       
    • By SayHiToRambo
      08 trooper 1100
      Bit of background. First the machine would take for ever to start. So I adjusted the valve shims into spec and made sure the timing is correct. Starts perfectly now. 
       
      now it fluctuates on idle. Bogs down, Revs up, repeat. I noticed the fuel pressure drops from 60psi to 20psi while that happens. It also bogs down at the lower end of each gear, higher rpm seems to be fine. Seems to struggle under load. In neutral it revs up perfectly. 
       
      brand new fuel pump, fuel filter, gas. I noticed on the fuel pressure regulator there’s that vacuum nipple, it’s not attached to anything and I’m not sure where it would go. Possibly the problem? 
       
      Another issue is the tip off the end of the exhaust is broken off, sensor is still attached and connected. Could that cause these issues? 
       
      my next plan was to look into the pressure regulator and voltage to fuel pump while driving. Is there anything I’m missing or any ideas you guys have? 
       
      thanks! 
    • By Prepper
      Hello All...
           Just bought a 2014 Massimo 500 UTV.  It;s not running at the moment, but hopefully will soon.  I need a seat for it also (passenger side, if it makes any difference.)  It is a crank-but no start situation.  Just now starting to read the boards for solutions.  Apparently these models are well known for this issue.  If anyone has any suggestions, please feel free to chime in, it would be greatly appreciated.
      Thanks 
    • By Chucky 1
      I purchased a new 2023 Landmaster UTV L4 in October of 2023.  UTV didn't seem to have as much power of the demo L4 that I drove but figured once it broke in it would be better.  After about a week the unit started bogging down backfiring and stopping.  Gas fumes really bad, wait a few minutes and it would start up again.  Brought it back to the dealer and after keeping it for a few weeks said he couldn't find anything wrong with it.  Got it back home and it started acting up again, brought it back to dealer a week later and he said he found couple things that might cause it to do run bad and he was able to replicate the issue but didn't really know what was wrong.  Got it back home again after being at dealer for several weeks and the unit started running bad again right away.  Brought it back to dealer and he went back and forth with Kohler about possible fixes but just checked somethings and try to swap a few parts but still runs bad.  I called Landmaster HQ to speak with someone about a refund and was told that was handled at the dealer level.  Dealer called Landmaster and they told him they didn't do refunds or exchanges especially with units that had problems.  The dealer is now trying to get a new engine to but I have not heard anything as of yet.  I did file complaint with Better Business Bureau and they accepted my claim and reached out to Landmaster.  The National Service Manager called me and said the he had been contacted by the BBB about the complaint and he would look into it.  I told him that I would just like to have my down payment of $2,000.00 returned and never mind the over $1,000.00 I have paid in notes for a UTV that I cannot even ride on without hoping it gets me around the neighborhood.  I have found out that the 2024 Landmaster UTVs will have Vanguard engines due to issues with the Kohler engines.  Very disappointed in what is "Proudly Made in the USA" and the way Landmaster has treated this disabled veteran! 
    • Get More For Your Device
    • By Tarak1980
      I have a Coleman HS400UTV-5 got it manly for hunting and spending time with the grandkids
      The one problem I am trying to avoid. My son borrowed it last summer and said it ran hot so he added water to it . I do not know how much he put in so I would like to drain most of it and add new coolant to protect it this winter. I can find no drain cock or any way of draining it besides loosening a hose.  Any suggestions ????
×
×
  • Create New...