Quantcast
Jump to content


Fuel Pressure

bigdan120

By bigdan120
in Joyner UTV SxS Forum

 Share

Recommended Posts

bigdan120 Rising Star

bigdan120

Posted
Posted

Ok I will start by saying I found my cat was plugged....Ok! that was fixed Cough Cough! Ran much better now...Ok now for the 2nd O2. Started looking at ways to fool the sensor..Did some research on it and found a couple ways..I don't know what is right or wrong..I'm a try it and see kinda guy sometimes... So if you buy a spark plug non fouler dorman 42009 at advance.( Same Thread as O2) Take it drill it out to 1/2 on the inside of it then install in the rear. Suppose to take it out of the stream enough that it just reads enough to work...I don't know if it works or not for sure. I can say that when I did that that it idled ruff and was acting all weird like it had a bad throttle position sensor... So I was messing around with it tonight and seen my fuel pressure was looking high..Like 65psi....Took and adjusted it down and it started running worse...Go figure! So I said heck with it and started turning it up and wala the miss went away. Now did the miss go away it is unreal the crispness of the throttle! Rediculously better! I mean WOW! Woke it up!!!! Can't wait to run it on the hills! So who knows but I do know this is the best by far that it has ran since I got it!

Chime in! I just wished I had a way to compare it to another one!

Ok well Going away over the weekend but I will be checking for updates! Have a Great Memorial day! Oh yeah check out Templeton Pa of Youtube....I gotta go there...Someone here is from there but it escapes me at this moment of who...LOL Sorry....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Kingfish
      Now that I have done the LI-Ion batt conversion, I need to do something about the suspension
      By Kingfish
      The conversion took about 350lbs. off the vehicle.  It never rode great, but now I feel every  crack in the road.  I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff.  I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order.  Does anyone have the data for the original spring compression rate?  I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
    • Woody77
      Stator replacement an now want start
      By Woody77
      UTV MASSIMOREPLACED STATOR WANT start replaced rectifier still want start stator ohms out 5 ohms each leg what could be wrong at this point 
    • Tony P
      2020 Hisun utv No power on console, no start...dead
      By Tony P
      Twice my hisun has been driven a few miles and turned off back at home. Get back on it same afternoon and console is dead, no lights. 
      Have 12.7 vdc at battery and fuses are good. I hear relays click in the fuse box and main relay clicks but everything is dead. 
      Any ideas on what this may be? I've seen this problem before on this forum but it never finished. 
      Any help is always appreciated. Thanks in advance! 
       
    • Rick A
      Hisun utv wont start no elec on dash
      By Rick A
      I charged the battery reconnected everything but utv will not start and nothing comes on when key is turned. such as headlights, dash lights nothing.
    • onealmck
      2019 T-Boss 410 Will Not Start
      By onealmck
      I have a 2019 T-Boss 410 that died one day after we parked it. It had been getting harder to start (had to hold the throttle down) for some time but would not start. The starter clutch seized while I was trying to start it. I replaced the starter clutch and it will not start. It appears to have solid fuel pressure and solid spark. It "fires" but will not actually run. The exhaust gets hot after cranking so I know that's actually firing but it won't fully start. Any ideas?

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...