Quantcast
Jump to content


Recommended Posts

Posted

Hey guys had the trooper out over the weekend 210 miles when in the white mtns of nh right up to the canada border beutifull landscapes up there! No issues with the trooper but got some questions cause I am not use to driving the trooper at 30-40 miles an hour for extended periods of time

Mine is an 09 1200 miles on it when should I do the t-belt

When your cruising along do any of you guys get gear type noise from your tranny not when accelerating but like at a steady speed easing in and out of the throttle my tranny has always been on the louder side the fluid is clean and I just changed it before the trip should I but a heavier grade oil in??

And I also notices I was getting a light rattle noise from I believe the front almost like as if u had two wrenches and were lightly tapping them together it came and went the noise I also noticed if I put my foot on the brake a little it stopped. Can't imagine it's a wheel bearing but maybe the brake pads rattling??

Thank Charlie

Posted

Yes my tranny always made noise when cruising down the road. If you are refering to the fan belt, it is fine. It will out last the rest of the Trooper. The clicking upfront on mine was the brake pads. Didn't bother me as my race cars always did the same thing. The Trooper doesn't have the little clips you install to stop the noise.

rocmoc n AZ/Mexico

Posted

thanx rocmoc and dan. I was talking about the actual t-belt behind the cover I know in the auto industry typically last 90,000-100,000. The noise I think is the brakes I will be pulling it apart this week to check. yes the tranny cruising down the road is when I hear it. The tranny like i said has always been loud just wanted to make sure it was normal cause I usually dont use 4th and 5th gears around home

Posted

Not so sure the noise is tranny, I think it may be the differential and I've had a noisy machine for several years and 16000+ kilometers, wish I could eliminate it, but can't, the front brakes do have slop in them an I always here a small slap every time it step on the brakes.

  • 4 weeks later...
Posted

Hey guys found the rattle noise in the front end some of it I believe was the brake pads so I put some anti seize lube on the outside of them and I found the one of the hyme joints at the rack had gotten little loose so I greased it and tightened it and no more noise

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • By Poppateets
      I just purchased a used 2023 Massimo warrior UTV SxS 1000mx with 600 miles on it. I didn't even get a full day of riding and the driver's side rear axle broke. I'm pretty sure it was already going bad because we would hear a noise once in a while. I'm wondering if anyone else has had problems with theirs. Also looking for places to buy accessories.
    • By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
    • By Dennis
      I have  a bulldog i bought from home depot in 2013.  In the last season it started refusing to shift from neutral to either forward or reverse.  I changed the trans axle fluid and made sure the cables were lubricated and free.  With a lot of coaxing, I can sometimes get it to shift.  once I start driving it, things improve until I let it set awhile.   Any suggestion on where to go from here?
    • By TPlummer
      We recently purchased the Axis x550. Fueled it with 93 fuel and drove one time around the farm and the 02 fault error appeared. Any ideas? 
×
×
  • Create New...