Quantcast
Jump to content


Recommended Posts

  • 1 month later...
Posted

Silverbullet

We are making the shim for trooper rear wheel bearing.We use them when we sell rear wheel bearing.We will have them in about 3 to 4 weeks.We have been told from Joyner China that there will be no more 650 rear differential being made.We have found that their is a option for and unlocked rear differential still being made.The only thing is the C/V axles will be different.So they will need to get new C/V axles to use the new open differential.This is what i have been told.We will have to see what happens.We have up dated our trooper and viper power steering with 360 watt motor and a bigger transmission.Rated for a 4,000 pound car.Completely water proof and 3 year warranty.We have up graded our hydraulic clutch with Wilwood pedal assembly and master cylinder.You only have to drill 2 holes to install.You just bolt it on and what a difference this system makes driving so much better.The cable system was just the worst thing on the vipers.They would stick and bind and made driving a viper a job to use and then the cable would break.

Thank You

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By JSwearer
      Does anyone have any suggestions for aftermarket shocks.  I have a T-Boss 550 and took it riding in some rough trails and the stock suspension was uncomfortably rough.
      Thanks
    • By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
×
×
  • Create New...