Quantcast
Jump to content


Recommended Posts

  • 1 month later...
Posted

Silverbullet

We are making the shim for trooper rear wheel bearing.We use them when we sell rear wheel bearing.We will have them in about 3 to 4 weeks.We have been told from Joyner China that there will be no more 650 rear differential being made.We have found that their is a option for and unlocked rear differential still being made.The only thing is the C/V axles will be different.So they will need to get new C/V axles to use the new open differential.This is what i have been told.We will have to see what happens.We have up dated our trooper and viper power steering with 360 watt motor and a bigger transmission.Rated for a 4,000 pound car.Completely water proof and 3 year warranty.We have up graded our hydraulic clutch with Wilwood pedal assembly and master cylinder.You only have to drill 2 holes to install.You just bolt it on and what a difference this system makes driving so much better.The cable system was just the worst thing on the vipers.They would stick and bind and made driving a viper a job to use and then the cable would break.

Thank You

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • By JSwearer
      Does anyone have any suggestions for aftermarket shocks.  I have a T-Boss 550 and took it riding in some rough trails and the stock suspension was uncomfortably rough.
      Thanks
    • By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
    • By Fordman1
      Cleaned fuel filter and am replacing mechanical fuel pump. Unbolted but can't get fuel pump out. Shaft sticks out and fuel pump hits axle and won't come out. Anyone had this problem?
×
×
  • Create New...