Quantcast
Jump to content


Recommended Posts

Posted

Hi I have a 2008 Joyner Renegade that died and will not re start It had been sitting for about 2 months while I waited for a new rear diff and then finally found time to work on it. It started OK after I filled it with gas and charged the battery. It started and ran for about 5 minutes and died I pulled the outlet line off the fuel pump and am getting lots of fuel the engine It has electrical power to all circuits as near as I can tell. Any schematics I have found are microscopic and when you expand them they are written in Chinese. I found one fuse box at the right front frame Who knows what the fuses are for They are not identified on the panel or cover. I replaced one fuse and all others were good I found some fuses and 3 relays tied up behind the battery Switched relays around and made no difference. There is a huge 40 amp fuse in line I cleaned the corrosion off the terminals on it. I still have the same issue It is cranking over, has fuel delivery to the engine but is not firing

Is there another relay/fuse panel I am missing? Does the system use a TPS and or crankshaft position sensor that could be the culprit?

Does anyone know of an on line service manual for this beast

Thanks for any assistance

  • 3 months later...
Posted

Did you check the coils with a spark tester? I just worked on a buggy that would start and only run a few minutes and then die. Chased the ghosts for weeks. Turned out it had a weak coil and it would spark pretty good on the first crank then the spark became weak or intermittent and would die. New coil and it runs fine. 

  • 4 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Rainman
      I want to put a charger/maintainer for my Coleman UT400 for the winter and need to know if it uses a 6v or 12v battery.
      One search online showed a 6v, but another stated 12v..
      I can look at the battery, but after taking the seat out you cannot see the top of the battery without also removing the top plate under the seat and at 8 degrees outside, I'd rather not be out there too long.
      Can anyone verify what volt (6 or 12) the batter is?
      Thanks in advance ...
    • By JDawg
      Was using the machine all day to haul wood...no issues until the end...
      When I try to start it, the dash lights come on but starter does not...seems like no power to the starter.
      It is in park, but when I put the brake on to start, it registers N.
      Won't start in neutral either...
      Tried rocking it, did not help...
      Help...
    • By boydog40
      my subaru gave it up, bought a new Predator 670cc
      problems is, wiring the buggy to the new motor, OEM key switch has 5 wires (red, green, yellow, black and brown)
      new motor has many more wires than the Subaru and i have no idea what goes where!!!
      finding any info on the web is almost impossible to do also
      any help will be greatly appreciated!
      thanks guys
    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
    • eManualonline.com Save 30% OFF Sitewide, Use code: XMAS30
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
×
×
  • Create New...