Quantcast
Jump to content


Recommended Posts

Posted

Parting out a mule 1000 kaf 450. Has hydraulic dump bed and good igniter. Let me know what you need and I will shoot you a price.

Located in Fresno ca and will ship

559 575 5028

  • 4 years later...
  • 2 weeks later...
Posted
On 5/27/2021 at 9:47 AM, Travis said:

there are 4 on ebay, but they're seem pricey around $80....

You're thinking of the filter boxes. The air silencer box (what I need) goes between the filter boxes and the carbs. It's the large box mounted right on top of the engine when you lift the bed.
There's 1 on ebay right now, but if you think $80 is pricey, you're gonna hate the $200 he's asking for it.
I use this mule at a 501(c)3 nonprofit museum, so I have a hard time affording that.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By rsar
      Hey guys. I was wondering if anyone pressure washes their Mule underbody. Three years in, I have yet to do this. I'm worried that the pressure washer could damage or dislodge something but it's gotten to the point that it could use a bath. Any thoughts?
    • By rdborra
      I had to remove the relay for the dump bed due to it popping the fuse for main key power. I have tried to find a short but nothing seems to out of normal. I also disconnected the dump motor and switch and still pops the fuse. Also, when the machine is warmed up i get about 5 to 10 of work out of before it stalls. Once I can get it to start again I have to use the choke to keep it running. 
    • By TjB
      My dad has recently acquired a 2510 Kawasaki mule Diesel powered. It worked fine  few weeks and then quit driving. Put a new belt on just to see. Still not driving. It already had a new clutch. Belt turns when in drive or reverse and back wheels are off ground to test. But wheels not turning. Thoughts? 
    • By Will D
      Hello, I have a mule 4010 trans that appeared to overheat based on the temperature light on the dash and it went into limp mode.  No steam though.  After letting it cool and the next day, I drove it around quite a bit and it did not have any problems.  Any ideas on this.  Do thermostats work intermittently?  I would like to fix the problem, looking for advice.  Many thanks 
    • By carl baney
      have a 2021 tracker 800sx noticed locks on box when u fasten both sides of box are cracked anyone else have this probl
×
×
  • Create New...