Quantcast
Jump to content


Joyner 250cc has no low end torque

tcisys

By tcisys
in Joyner UTV SxS Forum

 Share

Recommended Posts

tcisys Newbie

tcisys

Posted
Posted

Hello there,

I own a 2007 Joyner 250cc Sand Viper. It runs great on a flat ground and small hill and plenty of power for 250cc at top end(30-35mph). Perfect for my kids.

Never had any problem with power until few month ago, I decided to replace a new Carburetor, CVT belt, Clutch, and Spark Plug wire.

I also accidentally touched adjusting disc on the side of Engine. I put it back the best that I could according to the manual.

Now it runs great on a flat ground,But it couldn't climb up hills(15-20 yards, 30 degree). It just doesn't seem to have any low end power.

Any suggestions on what could caused to lose low end power?

Thanks,

Paul

Link to comment
Share on other sites
silverbullet Experienced

silverbullet

Posted
Posted

silverbullet

The first thing i would do is pull the CVT belt cover.Start the engine and put in neutral and slowly raise the rpm.The pulley in the front should start to to close and the belt in the back should open up(belt should be moving in to the center of the pulley. If it is not than there is the problem.Call me if you need help.But before you call do what i described in the begin of this note.

Thanks

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Goat Quilter
      Coleman utv 400 loses power uphill
      By Goat Quilter
      We pout new belts cleaned engine and carburetor plugs you name it.  Drove down road no problem came back uphill no power won’t go . What’s the issue? 
       
      could it be clutch? 
       
      frustrated in shop more than in use on farm 
    • Goat Quilter
      Coleman utv loses power uphill
      By Goat Quilter
      New belts and engine cleaned and checked carburetor cleaned drove on flat ground fine turned to go up hill lost power wouldn’t go 
      Could it be clutch issue?? 

      so frustrating this thing has been in shop more than used on our farm. 
       
    • didgeridoo
      Hisun Sector e1 Battery replacement: any tips?
      By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • mac66
      2021 Axis 500 4 month Review
      By mac66
      I bought a used 2021 Axis 500 last April.  Low mileage and got it for considerably less than what they go for new.
      The first thing I did was change the oil/fluids and also put a new drive belt on it.  The only other thing I did to it was add a rear vinyl window that zips open and rolls up to keep the weather off.
      I used it on my 52 acre property to check trail cameras, service the food plots, haul fertilizer, seed etc etc. It's has a good size bed and is not too big or small.  It has worked well as a utility vehicle. 
      Other than using on the trails working around the property I haven't used it much off road...at least until last weekend when I went on 74 mile group ride around the county. In my state it's legal to ride on any road that's not a state or federal highway. The group started in town, rode about 30 miles on back roads to the state ORV trail system. Then did about 20 miles on the trails and then headed back via back roads to town.   
      It had rained for 2 days straight prior, so the trails were one mud hole after another.  It was very challenging.
      The good...
      -It worked fine, never had any kind of issue with it since I bought it.
      -It kept up with more expensive machines on the trails. I was the only one with a CCC (Cheap Chinese Crap) machine.
      -Fairly comfortable to drive.
      -The roof, windshield and rear window kept most of the rain off when it started raining in the afternoon.
      -Okay, I cheated. I peeled off the AXIS 500 stickers on each side. Everybody in the group assumed I had a Rhino. They didn't ask, I didn't tell.
      The not so good...
      -The horsepower rating on the 500-cc engine is 24 hp but it seemed underpowered. While I could go about 35 mph with the pedal to the metal on pavement and hard packed dirt roads the best I could do on loose packed roads was 27 mph. I had trouble keeping up with the others in the group.  It also bogs down on inclines in high gear.  On the other hand, in low gear and 4wd I didn't have any problems going through mud or sand or up hills.
      -It is LOUD! Had to wear shooting earmuffs to keep my ears from ringing while riding. Going to have to address that.
      Overall Impression...
      I was impressed with it on the trails, and it is a good utility vehicle for working around the property. Considering what I paid for it I am very happy with its performance.
    • Grizz
      Power loss
      By Grizz
      Hello I bought a axis 700 two years ago and have had no problems until the other day was going down dirt road and lost all electrical power except lights and starter engine will turn over but not start and display panel went out so can’t see any codes can anyone help I’m getting up in years and my knees are not what they use to be. Thanks 

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...