Quantcast
Jump to content


Trooper has intermittent starting..

Tobie1987

By Tobie1987
in Joyner UTV SxS Forum

 Share

Recommended Posts

Tobie1987 Enthusiast

Tobie1987

Posted
Posted

My trooper intermitts when it wants to start.. it will always start cold..but if you shut it off it might start again and it may not.. it won't fire..but it you wait 5-10 mins it will start up just fine again until you shut it off.. I can't figure it out soo it's been idel if a lot lately..

 

 

Sent from my iPhone using Tapatalk

Tobie1987 Enthusiast

Tobie1987

Posted
  • Author
Posted

Yes just don't fire.. wait a few minutes and it will start right up and run fine until u shut it off again .. I'm gonna try putting new plugs in it tomarrow 

elderstang Rookie

elderstang

Posted
Posted

If that is the stock gauge, it probably isn't correct mine was showing 45 psi and when I put another one I had in the shop, it was more like 25 psi.

Go ahead and change your plugs (cheapest 1st) but I've never heard of plugs getting hot and not working. 

Fuel pumps and ignition coils usually. Keep us informed on how the plug change goes. 

Tobie1987 Enthusiast

Tobie1987

Posted
  • Author
Posted

So your fuel pressure is 45 or 25 psi... it is the fuel pressure...I watch my gauge.. when I shut it I watch it bleed back.. when it gets to just below 40 psi it will start 

Tobie1987 Enthusiast

Tobie1987

Posted
  • Author
Posted

I took it down to 30 and it doesn't doesn't wanna run that low and still having to delayed start problem...my ejk fuel controller instructions says to run it at 53-55 psi...

Tobie1987 Enthusiast

Tobie1987

Posted
  • Author
Posted

Yes.. i also turned the fuel pressure down to about 50-52 psi.. it wasn't running rich.. air/fuel gauge is running at about 14-14.5 warm..I took it riding the other day for about 6-8 hours and i had to wait for it to start a few times that morning but after that it hasn't don't it anymore.. I don't know for sure but I think it's was because i had it very very rich before and now I got it running pretty go now..


Sent from my iPhone using Tapatalk

  • 2 months later...
Tobie1987 Enthusiast

Tobie1987

Posted
  • Author
Posted

Start having the same problem again and when it does it.. it won't fire either...its was a loose ground problem on the transmission..its fine again .. for now..!!! Lol


Sent from my iPhone using Tapatalk

2scoops Proficient

2scoops

Posted
Posted

Glad you figured it out. At the end of the season last year Mine was dieing on me when coming off throttle from time to time. Then it didn't want to start afterward. I found oil in the intake and on the intake sensors. Also found a suspect air leak in a cracked intake rubber plug.  Cleaned the sensors and filled the plug with rtv and is running great. Keep an eye on rubber parts. They are always cracking. 

Kinarfi Veteran

Kinarfi

Posted
Posted

2scoops, from my experience, if you have oil in the intake, you may be having too much bypass around the rings, do you still have the oil/air separator mounted?  FYI My '15 doesn't even have one.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Topics

    • Nutcase
      Joyner trooper Fuel injection
      By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • Will Sutton
      Coleman UT400 won't rev. Idles fine
      By Will Sutton
      I've got a 2023 UT400 (bought from tractor supply) and I've been beating my head against a wall with it.
      It will start and idle perfectly. The second I touch the throttle it sputters and dies.
      I've checked that the fuel pump is working  (it is).
      I've replaced the injector, throttle position sensor, O2 sensor, and intake air sensor. All with no change.
       
      I've just taken a look a the schematic, and there is a crank position sensor as well.

      Could this be the source of my troubles? If so, where is this thing located? I can't seem to find it on any drawings from the parts suppliers.
    • Hunterman22
      2021 Hisun Axis 500 No Start - Need Help Please
      By Hunterman22
      2021 Hisun Axis 500 UTV (From Lowes)
      Will NOT START
      MY apologies if this is to much info just wanted to give yal the most information possible for help.
      I'm a so called diyer. An Electrician by trade 21yrs. I got my S×S from my last job. The contractor purchased this S×S for this specific job brand new, from Lowes. They used it for hauling materials, tools, & a little bit of anything you can think of on an Industrial type job site. 
      I remember getting on the SxS one time & pushed the gas petal all the way to the floor & SxS had very little power. 
      So anyway ,when the job finished up back mid July this year (7/2024) , I asked the contractor what they was going to do with it. I was told to take it. Otherwise it would go to the contractors yard (storage yard) & most likely rust away. 
      Took it home washed it , it had a heavy coat of dust on it & in it dust was every where. My helper & I had to push it on the trailer to get it home.  After washing it throughly I let it sit & dry out for a good day and half, maybe 2 days. Before trying to start it. NO START. Will turn over & try to start but thats it. 
      So here's what I've purchased & installed. New Air Filter, new spark plug, new air idle control valve (AICV), new throttle position sensor, new throttle body, new oxygen sensor, new digital dash speedometer/fuel gauge/clock. 
      Also drained the old oil & gas & replaced with new oil & 93oct. gas. I should probably mention that I've changed the AICV twice. The 1st time I changed the AICV I was able to get the SxS started & let idle for at least 10-15min. Drove out of the garage, with very little power,  turned it around & barely got it back in the garage.That was the one & only time I've been able to start the SxS. I've also cleaned the Throttle Body and & intake with TB cleaner.  So after that the AICV was  making weird noise so I pulled it out & tried cleaning it, pretty sure I messed it up. So I purchased a Throttle Body that came with new AICV & TPS. Still NO START.  I've checked the fuel pump & the fuel injector.  I took the injector off still hooked up to wiring & turned the key over, the injector sprayed a lot of gas out kinda the size of a volleyball. I've also checked the clearance gap on the intake & exhaust valve. But today 11/2/2024 I'm going recheck spark plug gap & the valve gaps. And alot of other checking. Would the driver side seat belt have anything to do with it not starting?? I know the driver side seat belt has to be in gauged for full throttle "going fast". Thing is the drv. side seat belt will latch but feels like might be messed up inside of it. Tired opening it up but to no avail.  I've never had a S×S or 4wheeler so I was really excited when I got the S×S,not so much anymore.  I work on & fix my own vehicles usually no problems.  But this SxS is kicking my ass.
      So if possible & someone could help me with some ideas or tell me what Im doing wrong or did wrong, I would greatly appreciate it.  Thank you for reading thus far.
       
       
    • fishhouse3
      2021 CFMOTO ZForce 800 Trail with many extras and full warranty until 2027
      By fishhouse3
      FOR SALE: 2021 CFMOTO ZForce 800 Trail with many extras and full warranty until 2027. Only 625 miles and 50 hours of use.
      In great condition, has a clean title and one adult owner. Has had all scheduled regular maintenance and has not been abused. Only used about six times on weekend trips to Hatfield-McCoy trails in WV.
      Under full CFMOTO Care bumper-to-bumper extended warranty until 8/2027 (paid $1,600). Full service and tune up just completed with new clutch, drive shaft, belt, rollers, etc (paid $1500). Plus it comes with over $3,500 in upgrades and accessories! Way too many included items to list here (see last pics for full details).
      This machine is ready to go and needs nothing - just hop in and hit the trails!  I have over $20k invested in this machine. Priced VERY fair to sell quick at less than half that!!!
      $9,999 WITHOUT warranty -OR- $10,999 WITH full extended warranty until 8/2027.
      Located in Chesterfield, VA 23832. Message me for more pics and info!





    • Clayton Walker
      Im New here but just got my Uforce Fitted for Hunting Season
      By Clayton Walker

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...