Quantcast
Jump to content


Recommended Posts

Posted

My new 2017 Polaris Ranger has tires going low. When I went to check pressures in all tires one cap was on tight and I noticed the valve stem rotated easily. I checked all 4 and  all stems spun with ease. Either the holes for the stems are too large or the stems are too small.
i'll get new stems and go from there.

Anyone else have the same problem?

Posted

In my Kawasaki Mule 550, my front left tire kept going flat, and the wheel wasn't properly "Seated" you might say around the tire it self, put stop a (1) can of stop leak, works perfectly now!

Posted

used soapy water but no bubbles at valve or rim, slow leaks are annoying. Could just be that 10 psi is not enough to keep them air tight.

Posted

I'd rather find the cause of the leak. Stop leak can throw a tire off balance to make it a problem  (on road driving) It goes 50 mph !

I could invest in a small electric compressor for the trail.

Posted

not at all, I didn't know they existed. The one that connects to your battery looks like a good one. I should get a tire patch kit too. Nothing like walking out miles from the trails just to walk back with repair items. A spare tire would be good but pricey.

Posted

we get ripped off here in Canada. Everything extra and add 30% more since our $$ sucks. First the bank of Canada lowered the $ and then the economy so the govt blamed it all on the economy and not what they did, go figure?  All our small products at grocery stores shrink and prices rise. I love going to Watertown and seeing real normal sized cans etc.

Posted

Hillary is one of many who was corrupted by Saudi $$$$$.   Trudeau has taken much from them by just looking at his immigration policies.

Posted

Yes most of us up north want this. Every time they vote in Liberal it only means higher taxation and free room and board for economic refugees.

We all work for the govt. here with ultimately 60% of our wages grabbed back as tax. I wish I was living in a state without income tax and near a bordering state without sales tax

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By hisun junk
      As I tried to do a conversion with the Yamaha 660 motor, I realized the 660 was never fuel injected so it would not work for the fuel injected hisun motor swap. But the good thing is the hisun 750 motor is a clone of the 660 Yamaha but with the components for the fuel injection (cam/crank position sensor). So that left me with a new rebuilt Yamaha 660 and still a broke 750 hisun motor. I took apart 750 think the timing chain had broke from all that I've heard about these motors. The chain was not broke, but just off cam and crank gears! The chain tensioner was at fault!  I've ordered Yamaha 660 replacement parts, chain, two exhaust valves (which got bent when chain came off while motor was spinning) and seals. The piston has 2 little nicks where it had hit valves but no damage otherwise. The head is being redone at the machine shop and I'll be putting it back together in the next couple of weeks. Also I finally tracked down a Service Manual with all the info on the 550/750 Challenger.

    • By Poppateets
      I just purchased a used 2023 Massimo warrior UTV SxS 1000mx with 600 miles on it. I didn't even get a full day of riding and the driver's side rear axle broke. I'm pretty sure it was already going bad because we would hear a noise once in a while. I'm wondering if anyone else has had problems with theirs. Also looking for places to buy accessories.
    • By Jacob E freeman
      I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then  it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
    • By Eagle Mountain Outfitters
      Our R&D team just finished the first unit and wanted to show you guys. Need more cargo space without losing the functionality of being able to fold down the seat to use the full bed? Eagle Mountain Outfitters, the maker of the original metal UTV roof, has designed a foldable rear cargo basket to meet your needs. Price is $625 + $30 shipping.  If you have any question's, please reach out to me at [email protected]
       

    • By mark walkom
      the regen braking on my e1 has stopped working unless (for eg) I am going down a hill in low and it's slowing things down to stick to the 10kph limit. when I drive and take my foot off the accelerator it's not initiating the regen to slow things down and instead just coasts at whatever speed it is at, or speeds up as the regen is not limiting it. the brake lights work, so it's probably not a fault with the sensor on the brake pedal
       
      hoping someone else might be able to provide some suggestions on things to check, as the mob that I bought it off seem to have gone silent on me
×
×
  • Create New...