Quantcast
Jump to content


EH65 spitting fuel from breather hose into air filter.


Go to solution Solved by Jim Kessell,

Recommended Posts

  • 4 weeks later...
Posted

I apologize to all who I left scratching their heads about my last post !!

Turns out to be fuel diluted oil coming from the breather.  I’ll be taking the carburetor off AGAIN !!!

Posted

Just like an old car or truck PCV valve.

PCV = Positive Crankcase Ventilation

Basically any gasses that blow-by the piston rings into the crank case need a place to go. So the PCV valve (one-way check valve) let the gasses out but doesn't allow any in. Usually a hose runs from PCV valve to breather and sent back into combustion chamber. 

Since the gasses are in the crankcase some oil may be pulled up as well.

Or it could be something else. Just a thought. Home this helps and good luck with the repair.

 

Kilgore.

  • 2 weeks later...
Posted
On 10/26/2024 at 1:51 PM, Jim Kessell said:

I apologize to all who I left scratching their heads about my last post !!

Turns out to be fuel diluted oil coming from the breather.  I’ll be taking the carburetor off AGAIN !!!

Jim,

Have you checked oil level in engine? Does it smell like gas? If overful it could be sucked by the breather back to carb.

Posted

WB

I was hoping you would respond. 
It was definitely gas infused and slightly over full. Took the carb off and changed the float and needle valve.  Reworked the fuel solenoid.  I have it running pretty well now but was having the issue with the blow back. 

  • Like 1
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By boydog40
      my subaru gave it up, bought a new Predator 670cc
      problems is, wiring the buggy to the new motor, OEM key switch has 5 wires (red, green, yellow, black and brown)
      new motor has many more wires than the Subaru and i have no idea what goes where!!!
      finding any info on the web is almost impossible to do also
      any help will be greatly appreciated!
      thanks guys
    • By Bjabbarw
      My 2021 Odes Dominator 800 bogs down at 25mph and won’t go over that speed. I have changed the fuel pump and it still does the same, it runs and idles fine, it has great reverse speed, but it won’t accelerate past 25mph. Any Ideas?
    • By vachi
      hi everyone i have this 2021 Hisun forge 250 that won't start. no spark no fuel.   when i turn the key on i dont hear the relays click or fuel pump come on. it does have power but the relay doesnt ground the pump or the ignition coil. dont know if there are any safety switches on this model or not.  it does crank and all the accessories work. i  hot wired the pump and it does work.  i found a wiring diagram but it's very hard to figure out and was hoping someone has seen this before. all fuses are good. thanks in advance. 
    • By Robby
      Hello, I have a 2013 500 utv hisun. Was running ok and cut out while parked. Bike will not start now. It turns over, but won't fire. I have no spark and no fuel. I replaced fuel pump, ignition coil, spark plug, cdi, voltage rectifier and all the fuses and relays. Could bad stater cause no fuel because I can't hear the fuel pump priming. Any info on where to start looking for problem.
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
×
×
  • Create New...