Quantcast
Jump to content
This Topic


Hisun 750 crew 2016

Budmanbiker

By Budmanbiker
in Hisun UTV SxS Forum

 Share

Recommended Posts

Budmanbiker Rookie

Budmanbiker

Posted
Posted

I have a 2016 750 crew (it is a Cub Cadet but same machine). It has 108 hours, 49 miles. Basically new, but I got it used with 22 miles on it. The guy said it was too big, and that he wanted a RZR. It ran great for a little over a year. It then developed a rough idle and won't wind up to get past about 20 mph in high range. I have tried countless things, and I keep coming back to overfueling. It doesn' seem to be throwing a code.  I have done the following...

Spark plug (multiple times)

Check, clean air filter 

Sprayed brake clean around intake while running (to be sure it isn' sucking air).

Checked valve adjustment

Replaced fuel pump assy., after breaking it trying to remove to check in tank filter.

Checked wiring and connections

Checked/cleaned spark arrestor screen

Replaced fuel, trying different octane. 

Checked compression.

Compression should be 1200 kpa,  mine was between 700 and 800 kpa.  Also noticed oil had been increasing and is now milky looking. I figured gas in oil due to overfueling. Dad said milky or foamy meant coolant in oil so we figured blown head gasket. So, we put a new head gasket on it. Old one didn't look blown. Valves were tight like new, could still see cross hatch marks in cylinder wall (like new as it IS still new!) Put it all back together, torqued bolts properly etc... no change. Still runs poorly, compression still low! I don't think it is a compression issue. We pulled the rocker cover back off to check out the automatic compression release that we had noticed on the timing chain  sproket on the end of the camshaft. It seems to be working properly. Then a lightbulb went off. "Automatic compression release" appears to slightly open an exhaust valve... when?... while cranking engine to start. There is no way that we're going to get 1200 kpa compression (unless I were to back that exhaust valve way off)! I may try that when I re-install the rocker cover.  

Anyway, I'm pretty convinced that it is fuel in the oil, and that it is over fueling like I originally suspected. But how do I know the cause?? Book says over fueling could be caused by Air Pressure sensor, o2 sensor, Solar Term door position fault, or ECU program error or damage. Those are some pricey parts.  Any input??

 

aussie1 Apprentice

aussie1

Posted
Posted

Disregard compression for now.  What about injector?  Remove it then reconnect it and hold in a glass container. Wind the motor over and observe spray pattern. If  the fuel "squirt"a  fine mist all is OK. If a "stream" you have a faulty or clogged injector. 

Fault codes can be difficult to follow but will only guide us to an electrical fault. Test the injector then we can dig further. PS higher octane fuel should not be necessary.

  • Like 1
Budmanbiker Rookie

Budmanbiker

Posted
  • Author
Posted

Thought about trying that, but really didn't know what the spray should look like. I need to put the rocker cover back on tomorrow and will certainly give it a try! I am still in the shop, but the focus has turned to drinking beer with a friend. Lol. Thanks for the suggestion!

  • 2 weeks later...
Budmanbiker Rookie

Budmanbiker

Posted
  • Author
Posted

Update... I tried to clean the fuel injector after watching some how to videos on YouTube. The spray pattern never changed, still shooting a "v" pattern. So I ordered a new injector for about $150.00. It arrived today and I installed it. It sprayed the same pattern as the old injector and it still runs like crap! 

Budmanbiker Rookie

Budmanbiker

Posted
  • Author
Posted

I tried unplugging the 02 sensor while it was running. The idle immediately sounded healthier so I took it down the road. It still wouldn't quite let me give it full throttle without it loading up, but it had much more power, and I was able to get it up to 43 mph. With the 02 sensor plugged in it will only get up to about 35 mph. Top speed on this thing when it ran right was about 54 or 55 mph. Would this indicate a bad 02 sensor?

  • 9 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • CapnWalleye
      2016 Hisun 500 runs rough no power
      By CapnWalleye
      Just picked up a Hisun 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • CapnWalleye
      2016 Cub Cadet 500 runs rough
      By CapnWalleye
      Just picked up a Cub Cadet 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • FTG-05
      Want a new work UTV; who and what should I look for?
      By FTG-05
      I want to ditch my Kubota RTV-XG850 and its moronic twitchy throttle design flaw, get rid of the problematic engine and the 40 mph purposely throttled speed.
      So far, I'm looking at the Honda Pioneer 1000 and the Polaris Ranger 1000, both of which have 1000-1500 lb payload bed capacity.
      What other makes and models should I be looking at?
       
      Thanks for the help!
    • D MAYNARD
      Axis 500 4x4 turns over but no spark
      By D MAYNARD
      I have an Axis 500 4x4 UTV that I was given.  It looks like an almost new machine with 39 hrs on it however it was apparently under water from the hurricane . I have no spark at the plug. I have replaced the plug, the plug wire, & the stator so far. Can anyone advise me of what i need to check and or replace to get this thing running? Any advise would be greatly appreciated. 
                                    Thank You,
                                  D Maynard 
       
    • ned
      What year is my RTV
      By ned
      I have a Kubota RTV -X900 that I recently got from someone that is in good condition.  I'm trying to determine what year it is all to no avail.  I have the 16 digit product identification number and have gone on line to multiple sites with no luck.  The number is A5KB2FDBCFG024444 .  I'd appreciate it if someone could give me an idea where to look this number up and get the year on this unit.  Thanks in advance.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...