-
Similar Topics
-
By Jacob E freeman
I have a 2018 cub cadet challenger 750 I bought brand new almost 2 years ago the first month I had it the exhaust broke and burnt the spark plug wire in two that was a recall so the dealership installed the new one it had a different design and it bolted up to the bottom two plugs below the spark plug the dealership said they had to Adjust the exhaust valves I get the machine back thanking everything is good now wrong not even a week after I get it back the timing chain tensioner comes apart inside the motor I take it back to the dealership They put one on I get the machine back thanking everything is good but then just like before not even a week goes by when I was riding the Machine automatically quits going come to find out the wet clutch was burned up the primary clutch head stripped off of the splines I get that fixed and then it overheats I take it back they bleed the air out of the coolant they bring it back to me the same day that I get it back it overheats again I take it back they temporarily fix it again just enough to let the warranty run out and now the machine has been to multiple different mechanics I have had them try to bleed the air out they have stood it up on its end I have had the water pump changed I have had the fan hooked to a switch so I could leave it on all the time but still almost 2 years later not even 200 hours on the machine and I cannot ride it The dealership will not take it back as a lemon I have tried I am at my wits end I have no clue what to try next
-
By Joe Breaux
I am being bombarded with ads here now for some reason.Its reaching the point of not being able to use the site for all the pop-ups clogging my screen.
-
By cliffhodges
Hi All- Long time reader, first time posting. I have a 2016 Mule 4010 (model: KAF 620V). I am having an issue since overloading the payload a couple days ago (yes I'm a dummy). I live on a very hilly property and I was trying to move some large oak rounds for firewood splitting. I put WAY too much wood in the bed and when I started driving, it sputtered, kicked out of gear, and then cut out. I unloaded all the weight and started it again - appeared to be running fine when idling and/or driving on flat ground at slow speed. But when try to go fast or uphill, the RPM's rev high and it sounds like the motor is fine, but it has ZERO speed or power at all (literally creeps uphill at like 2-3 mph and won' go faster or take any weight), and has no power at all.
Other info: 3 weeks ago I did a belt replacement. So I was worried I perhaps screwed that up somehow. But I just opened the clutch housing to check and the belt and clutch appear to be working just fine.... sooo.....
Any ideas what I screwed up by overloading payload and immediately trying to drive uphill? Any tips would be greatly appreciated!
-
By Joe Toup
There is a lot of great info also being passed around on this FB page of anyone is interested. This is where I found the post for the real-time software and reader.
https://www.facebook.com/groups/187829158450490/?ref=share
-
By KTMspeedFreak
For some reason, out of no where all my tranny flue is leaked out from around one of the seals in tranny where the drive shafts come out.
Buggy was in the garage for few days with no leaks, then randomly all the oil just started dripping out from one of the seal areas?? I didn’t even move the buggy... The only reason I can think as to why it went from zero leaks to major leak is the cold weather here in FL may have shrunk the seals?? Anyone else think this is rather strange? 🤨🧐
Also, antonella’s know where I can order these?
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now