Quantcast
Jump to content


Strike 1000 Trans Oil

Jeremiah Hammond

By Jeremiah Hammond
in Hisun UTV SxS Forum

 Share

Recommended Posts

Jeremiah Hammond Newbie

Jeremiah Hammond

Posted
Posted

Hey everyone, got a strike 1000 in on a trade awhile back, me being dumb I didn’t check the fluid when I got it. Turn out guy had swamped it pretty good. Front diff, rear diff, and trans were full of water/oil/sludge. I don’t have a service manual only an owners manual and it do not state the type of oil the the trans takes or where the filler cap is for it. I have everything else taken care of so far just not the trans.

 

Any help is appreciated.

  • 2 weeks later...
Farmer Newbie

Farmer

Posted
Posted

Just looked at the service manual for 2018-19 Strikes. All I could find was SAE-80 GL-4 for the final gear and SAE 80 GL-5 for the differential. I know Bel-Ray and VP Racing make a nice semi synthetic, I've even used them in Polaris. If your still having trouble with water in the crankcase, some marvel mystery oil will save you some oil changes. I've taken completely swamped rigs and had them water free in 3 changes.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • ToughLuck
      2021 Massimo MXU 1000 Runs Rich
      By ToughLuck
      I have a 2021 Massimo MXU 1000.  Last winter the front drive shaft sheared off inside the motor and it was cheaper to buy a new motor than to take it apart in order to remove the front drive shaft that was broken inside the case…
      Now it is running rich, seems to maybe be geared too high, does not accelerate well once you hit about 28mph.  I’ve replaced the O2 sensor.  MAF is next (I accidentally ordered the wrong one, but when I removed the old one you can clearly smell fuel).  
       I’m not a motorhead but I can turn a wrench.  Any ideas how to get this motor optimized?  The motor has about 300 miles on it.  I broke it in as recommended in the manual. 
    • Will D
      Mule 4010 trans overheating
      By Will D
      Hello, I have a mule 4010 trans that appeared to overheat based on the temperature light on the dash and it went into limp mode.  No steam though.  After letting it cool and the next day, I drove it around quite a bit and it did not have any problems.  Any ideas on this.  Do thermostats work intermittently?  I would like to fix the problem, looking for advice.  Many thanks 
    • strike250
      Free Massimo Buck 400 service manual
      By strike250
      I have the factory service manual available for the Buck 400. Just send me a message with your email and I'll get it to you. Although there is no charge for this, it would be great if  you would visit my website where you could donate any amount to help do things like this with others who need it. Again, there is no charge for this manual, and no obligation to donate. But if you did, I would thank you for sure. Have fun on the trails. www.warriorsoffroad.com
       
      Matt

    • mcraigchr
      550 - Diff fluid change and final drive?
      By mcraigchr
      Howdy y'all,
      I have the service manual, but it leaves me with questions.
      1)  It is time to change the diff fluid.  The service manual says 80w-90 for the rear and Dextron 3 ATF for the front!  Is that correct?  That seems odd to me.
      2) The service manual also speaks of the need to change the transmission fluid but gives no detail about it.  What needs to happen here?
      3). The service manual also discusses changing the final drive fluid with 80-90 Hypoid.  Is the final drive actually the tranny?
      Any details about the changing of the fluid or what fluid to use ... or even other things that need to be changed that the manual does not mention would be appreciated.
      Thanks,
      Craig C.  
    • Jim Kessell
      Predator 670 manual oil pressure gauge
      By Jim Kessell
      Hi All
      Just installed a predator 670 on my Landmaster. My question is can I remove the low oil pressure wire fitting and plumb my mechanical gauge into that access point?
      Thanks in advance for your advice !!
      Jim

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...