Quantcast
Jump to content


Recommended Posts

Posted

I had to rebuild my steering box recently and need to replace the 2 square dust boots on the box. Joyner does not have them in stock and probably won't anytime soon. Does anyone know of an alternate replacement for these? Any help would be appreciated 

  • 10 months later...
  • 4 weeks later...
  • 7 months later...
Posted
On 12/28/2020 at 8:11 PM, mixfixdave said:

I found some steering rack and pinion boots that work for the Trooper 1100!
Post up if you are looking.

These boots were a life saver for me. Thanks so much for sharing. I had a problem with the Joyner boot clamps not holding the boots on. They would slide off the steering box. To fix it I added some strips of leather under the clamp straps to make them tighter. So far it is working.

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By SouthernGypsy
      We have a 2018 Cub Cadet Challenger 400 and I found this Internally Threaded Bolt with a 10mm head size laying in the floor of the shop bay here on our ranch where we park the Cub Cadet.
      Trying to figure out where it belongs...
       




    • By se3388
      Hopefully someone else will buy a UT10X and join in.
       
      Steve.............
    • By JOSEPH LAMAR
      I have a 2020 axis 500 and I have replaced the TPS twice and the whole throttle body assembly once and still have code 122. I can barely drive the thing. It bucks and surges like crazy
    • By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • By Texjpr
      2002 ranger 500 4x4 stopped running and wouldn't restart. Service manual wiring diagram helped identify the hub safety switch as the culprit. Using jumper wires to bypass  switch allowed the engine to start and run normally. Inspection of switch showed melted epoxy and a strong smell of burnt electrical. Unable to find replacement part either used or new. Is there a work around other than jumper wiring?
×
×
  • Create New...