Quantcast
Jump to content


Recommended Posts

Posted

So I guess my Coleman Outfitter is a rebadged Sector 550.  I am wondering what if anything others do to protect their winshi9elds when trailering.  I have a camp in Lake co Mi and I will be trailering it about 5 hrs each way from Sandusky Oh.  My bikes and quad don't have windshields so I never worried about it but I have seen others putting plywood or other covers over theirs.  FWIW the whole route is on paved roads.  Dirt starts 1/4 mile north of my camp.

IMG_20200430_113758.jpg

Posted

All it takes is one unlucky rock. I'd probably make a padded plywood cover for the windshield. The padding to protect the plexiglass from the plywood. Cut four hand sized holes around  the outside edge for handling, and also to run the ratchet straps through. 

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By JSwearer
      Does anyone have any suggestions for aftermarket shocks.  I have a T-Boss 550 and took it riding in some rough trails and the stock suspension was uncomfortably rough.
      Thanks
    • By Homeowner A
      I have a Coleman UTV 400 and looking for something to store it in.  Preferably something vinyl or plastic with its own base that can stand alone outside and house the UTV.  I think the dimensions of the UT400 are around 106" long 52" wide and 74" tall. 
      What should I consider that won't break the bank?    
    • By Howard Elmore
      I have owned mine for a couple years now but newer took off road.  How well does it do trail riding m?
    • By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • By Will Sutton
      I've got a 2023 UT400 (bought from tractor supply) and I've been beating my head against a wall with it.
      It will start and idle perfectly. The second I touch the throttle it sputters and dies.
      I've checked that the fuel pump is working  (it is).
      I've replaced the injector, throttle position sensor, O2 sensor, and intake air sensor. All with no change.
       
      I've just taken a look a the schematic, and there is a crank position sensor as well.

      Could this be the source of my troubles? If so, where is this thing located? I can't seem to find it on any drawings from the parts suppliers.
×
×
  • Create New...