Quantcast
Jump to content


Questions on 2017 Challenger 750 crew

NewCadetOwner
 Share

Recommended Posts

NewCadetOwner Contributor

NewCadetOwner

Posted
Posted

Hello everyone.  I purchased a 2017 Challenger 750 eps Crew with 400 miles and find the exhaust noise is awful.  I saw in another post chatter about a 2019 exhaust upgrade?  Anyone have info on this?  I also would like to know the typical RPMs for speed.  I am running 4k at 20mph in hi range and it seems like it does not have the power I expected.  

So far I have added a custom mount rear winch, soft rear window and upgraded LED headligjt bulbs.  I am looking for any other upgrades people have done.

 

Link to comment
Share on other sites
NewCadetOwner Contributor

NewCadetOwner

Posted
  • Author
Posted

Well that could be.  I have seen other complaints about the noise.  I dont have anything to judge it by.  I am going to take it to the dealer and have him go through it.  The machine is like new and Im getting 15 miles per gallon so it seems like engine is running efficiently.

  • Like 1
Link to comment
Share on other sites
Verno Contributor

Verno

Posted
Posted

The exhaust upgrade does not do much for the noise, it just removes the likelihood of breaking the pipe going to the muffler.  Most of my noise cam from a cracked pipe. It helps to duct the air piping from the clutch to the rear of the cab.  Both intake and exhaust.  Mine runs 5500 rpm at 40 mph.  6000 at 45.  The gas mileage was much closer to 25 mph.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Jon V
      reassemble Cub Cadet Challenger 700 - Crankshaft does not turn freely
      By Jon V
      Good afternoon. When the timing chain came off its lower gear (previous owner had over-tightened the tensioner), I ordered new parts.. chain, oil-pump chain, tensioner etc.. But now that it's time to put it back together, the main crankshaft makes a clang noise and stops when you turn it by hand. I want to solve this before assembling everything. The camshaft cover is off so that the valves aren't being activated. Should the transmission be in neutral to turn the crankshaft? The engine was running fine until the chain came off the lower gear. Then it would spin when the starter motor engaged so I assumed the crankshaft was spinning. Any advice is appreciated.
    • Goat Quilter
      Coleman utv 400 loses power uphill
      By Goat Quilter
      We pout new belts cleaned engine and carburetor plugs you name it.  Drove down road no problem came back uphill no power won’t go . What’s the issue? 
       
      could it be clutch? 
       
      frustrated in shop more than in use on farm 
    • weasel
      Coleman 400 UTV fuel issue
      By weasel
      starts up you have keep rpms up for 5 minutes till it warms up then runs fine. But if it stalls wont start unless you unplug fuel pump and hold it to the floor till it starts then plug pump back in and run it till it warms up then it is fine all day.
    • hisun junk
      Challenger 750 - junk hisun motors!
      By hisun junk
      I have a 2018 cub cadet challenger 750 with a broke chinese hisun motor and I know that I'm not alone! Almost all the places that were selling them in Colorado don't anymore due to the return for repairs on the clutches and broken timing chains! Don't have yours fixed because it will happen again! They just replace the broken parts with more junk chinese parts! I talked with a UTV mechanic that has replaced one person's clutch 4 times! I have people contacting cub cadet about these problems and also looking into complete motor replacement from hisun junk to a Japanese motor in which the chinese cloned their junk from.
    • jonny L
      2019 cub cadet challenger 750
      By jonny L
      Went for a nice trail ride for about 20 miles, came back, shut it off, and attempted to go for another ride. The electronic gear shifter will not go into park to start it up.  It reads neutral in the park position. Disconnected the battery and reconnected and it now read Park. But, when you put your foot on the brake to start it, it goes right back to neutral. Checked everything that I could think of and decided it has to be the 17 gear position sensor. Not certain this is the issue but I bought a used one on Ebay (could not locate a new one) and will try it. Any other possibilities?

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...