Quantcast
Jump to content


2012 Joyner R2

Yourname

By Yourname
in Joyner UTV SxS Forum

 Share

Recommended Posts

Yourname Newbie

Yourname

Posted
Posted

Hi everyone new to utv board

I have a 2012 Joyner R2 im having a loss of power unit idles fine and starts right up but bogs down around 2000 + rpms unit will then begin fluctuating high rpm low rpm Repeatedly under throttle  it’s  almost like it’s in a limp mode fuel line will stiffen and go back loose again I can see the pump look like it’s cutting on and off while this is happening  I I have changed all vacuum lines fuel lines changed FPR and fuel pump And also the injectors  and I have swapped out the TPS sensor 

Dan B Community Regular

Dan B

Posted
Posted

Things to look for:  Check your fuel pump pressure.  Should be a constant 50psi give or take a couple of psi's.  The pressure regulator might be going bad.  Ensure you have the full 12vdc to the fuel pump.  Check the fuel pump relay, also.  A loose wire or bad relay contact can cause intermitten fuel pump operation at higher RPMs (more vibration).  Fuel demands at idle are much less than at higher RPMs.  That's why it starts and idles fine.

Neil Wilson Contributor

Neil Wilson

Posted
Posted
On 10/29/2020 at 3:26 PM, Yourname said:

Thanks for the reply I just got a new fpr in today so swapping that now I will check all that you’ve mentioned much appreciated!!

You should be able to borrow a fuel pressure tester from your local auto parts store. Connect it between the pressure regulator and the injector rail. That is the sure way to know what is happening at the injector rail.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • CapnWalleye
      2016 Hisun 500 runs rough no power
      By CapnWalleye
      Just picked up a Hisun 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • CYJSP2009
      Joyner parts
      By CYJSP2009
      Dear Joyner owners
      Any one who is looking for below Joyner parts please send email to casey from Leaf Asia  ( please send to [email protected] and cc to casey2leafasia.biz & [email protected])
      Currently, we have supply below parts: 
      1.  cv axles, cv rebuild kits, cv boots
      2.  Differentials and differential ring and pinion set
      3. Cables, 
      4. Brake parts
      5. Engine parts
      6. Other parts. 
      We will provide better price, close follow up ... 
      We can arrange productioni for parts that we can collect demands from customers  
      Have a good weekend
      Casey /  Leaf Asia 
      2023-11-17
       
    • CSM_Retired
      Kioti UTV SxS Forum
      By CSM_Retired
      This is for all of you Kioti Off-Road UTV, SxS (Side by Side) owners. Discussions about Kioti Off-Road specific topics including the Kioti Mechron, K9, 2400, and 2440 models. 
    • Homeowner A
      Code Reader for Delphi MT05 Coleman UTV 400 Hisun
      By Homeowner A
      Is there a code reader available for the Coleman UTV 400?  I tried using the HUD ECU Hacker software and cables/adapters but no luck OBD to delphi 6 pin and KKL VAG as well as ELM327.  Will not connect.  I was able to get it to connect randomly a couple of times, but haven't been able to since.  I was able to clear and read the codes briefly.  I'm aware of the Tiny Scan 301 but it doesn't seem to be readily available.  There's a few out there but they are expensive.  
    • FTG-05
      Want a new work UTV; who and what should I look for?
      By FTG-05
      I want to ditch my Kubota RTV-XG850 and its moronic twitchy throttle design flaw, get rid of the problematic engine and the 40 mph purposely throttled speed.
      So far, I'm looking at the Honda Pioneer 1000 and the Polaris Ranger 1000, both of which have 1000-1500 lb payload bed capacity.
      What other makes and models should I be looking at?
       
      Thanks for the help!

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...