-
Similar Topics
-
By Jim Kessell
Hi All
Just installed a predator 670 on my Landmaster. My question is can I remove the low oil pressure wire fitting and plumb my mechanical gauge into that access point?
Thanks in advance for your advice !!
Jim
-
By CSM_Retired
View File Kioti Daedong K9 2400 Shop Manual
This manual is to provide servicing personnel with information on the general speci- fications, service, operating principle, troubleshooting, exploded view including part name, removing and installing procedures for K9 2400/K9 2440 UTV (Utility Vehicle) with high-end technology.
All information in this manual is based on the latest product information available at the time of publication. Therefore, some of the information in this manual may differ from the machine you have.
KIOTI has a principle to apply update to the next edition of the manual if there is any. However, KIOTI has no obligation to modify the contents in this manual, especially the contents in the manual which is already distributed or published.
The modified information is available in KIOTI's online electronic manual system (DEMSS).
This manual is ultimately to satisfy customers with best performance of this UTV. If there is any typo, wrong information or question for this manual, feel free to contact KIOTI.
Submitter CSM_Retired Submitted 01/02/2025 Category KIOTI
-
By WCF
Hi Joyner Gang
New to the Joyner group. I'm making long travel for the 1100 Sand viper. I'm trying to make something that will work as well or even better than the RZR Rino etc. At this time the front has 14" travel rear has 16" of travel. Still developing the suspension. comets are welcome. Ask questions and I will get back to the Forum
?
-
By Hunterman22
View File Hisun Axis 500-700 Service Manual (2020 Version)
This is the 2020 updated version from the previous 2009 version. I do not know all the differences. I do know the 2020 models have throttle body , idle air control valve, & idle control sensor.
HS700UTV-4/HS500UTV-4 Hisun Axis 500-700 Service Manual
Submitter Hunterman22 Submitted 08/10/2024 Category Hisun
-
-
By Off Grid Refugee
I have a yanmar longhorn 6 seater which I believe is having fuel delivery issues. It will run off of starter fluid and will sometimes run on gas but will not idle. Fuel pump is new and verified to put out 56 psi. Injector is new, I'm reading 10.5 volts at the injector, gas is new. The unit will run when the engine symbol is not present at the gauges. Diagnostic port doesn't appear to be present, can't find it where yanmar says it should be. Oil is full but old. Any ideas what's going on here? Is there a maintenance function that will shut this machine down if it has old oil?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.