-
Similar Topics
-
By mhill
I purchased a 2008 American Sportsworks Subaru TW265 UTV, with no manual and no previous knowledge. When idling, the steer column shakes uncontrollably, is very noisy, and might be from vibrations from the engine. Logically, I am thinking engine vibration moving up the steering column. I found a schematic, but that has not helped in identifying the specific problem.
Any thoughts? Suggestions?
Thanks so much
-
By staind
Looking for information on installing a OBD port or a lite to read codes in ECM.
I can not find a OBD port or a lite to read codes on this R2 with 800cc.
I have code readers and adapters for most ATV's. From what I've found so far. They don't have a connection for to read codes. I may be wrong. That's why I'm asking.
This R2 has had new IAC, TPS, MAP, fuel pressure regulator and fuel pump replaced. This was done by neighbor to try to stop surging. It still surges on start up and then settles down. But once you hit the accelerator it revs up to 2000+ rpm and stays till you block off IAC port in throttle body with finger. Once you do that it once again settles down and idles perfectly.
I want to know what the ECM is reading to help dio it.
This joyner is the first one I've run across. Well second one in a week. (my neighbors 2 of them) The other was a trooper with the 1100cc chery motor that had been setting for years. After cleaning up the fuse box connections. It runs like a top. Had to replace all gages with aftermarket gages. Water, oil, gas, amp. Only problem one was the water temp using original sending unit. Had to install 150 ohm resistor on the input wire to get it to read correctly + - 5 degrees. Close enough. Gas sending unit was/is for a boat tank 6" tall. All SS so it should last forever.
thanks Dan D. aka staind
-
By Troy C
I am new to forum but I have a 2012 polaris ranger 800 that motor went out and had it replaced and a year later here i am again so i am interested in converting it to EV . I am 72 but pretty active and live on 500 ac of land that part is in hills but most is in low land. I have no idea what i need or want so any advice will be appreciated. Thanks guys
-
By CSM_Retired
View File Kioti Daedong K9 2400 Shop Manual
This manual is to provide servicing personnel with information on the general speci- fications, service, operating principle, troubleshooting, exploded view including part name, removing and installing procedures for K9 2400/K9 2440 UTV (Utility Vehicle) with high-end technology.
All information in this manual is based on the latest product information available at the time of publication. Therefore, some of the information in this manual may differ from the machine you have.
KIOTI has a principle to apply update to the next edition of the manual if there is any. However, KIOTI has no obligation to modify the contents in this manual, especially the contents in the manual which is already distributed or published.
The modified information is available in KIOTI's online electronic manual system (DEMSS).
This manual is ultimately to satisfy customers with best performance of this UTV. If there is any typo, wrong information or question for this manual, feel free to contact KIOTI.
Submitter CSM_Retired Submitted 01/02/2025 Category KIOTI
-
-
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.