Quantcast
Jump to content


Recommended Posts

Posted

son got an old qlink sxs, at first wasnt starting good and was leaking fuel very bad out carb and pooling under it. had a hose off that seemed to go from tank to highest nipple on carb..... put hose back on, cleaned carb, and plug. now doesnt leak and cranks fine, but once engine warms wants to cut out back fire and die.....will crank right back up and idle fine until give throttle ....i mean looks like a carb to me ........has fuel pump though.....i dunno if those two will even work correctly together, does this sound right? or did someone just try to force this to work? please help!!!!!
 

Posted
10 hours ago, Travis said:

post some pictures if you can.

you'll probably need to remove the carburetor and clean it thoroughly.

^^^This^^^ 99.44% of the time now, with this damned ethanol gasoline, you'll find a jellied up ball of crap in the float bowl or diaphragm cavity if a diaphragm carb...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Homeowner A
      Picked up an essentially new 2022 UT400 with 9 miles on it.  Decided to change the oil because it's probably never been done.  Pulled the dipstick and noticed it was overfull then went and pulled the drain plug and took off the filter and it was like brown water running out.  What should I start checking?
    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
×
×
  • Create New...