Quantcast
Jump to content


Recommended Posts

Posted

Is it as inaccurate as the one I got with my Outfitter 400--which among other things placed the spark plug under the seat (it's not, it's under the cargo bed); and the air filter under the bed (It's not, it's under the seat). Apparently on earlier 400s the cylinder slanted forward, on my 2020 it slants rearward--don't know when that was changed but the OM has yet to catch up with it.

EngineSlantsBack.thumb.jpg.cd997271190815093061f5cec3343a6a.jpg

 

The manual supplied with the vehicle also referenced using the  choke  when starting the engine; it even had an illustration of the nonexistent "choke"--my 2020 is EFI, no choke--it made no mention of the steering column mounted ignition switch/steering lock or horn, light switch/turn signals. The "jump starting" instructions began with "Opening the hood" to access the battery--the battery is under the seat...

I complained to Coleman and they sent me an "updated"manual which corrected the  switch issues but continues to misplace the spark plug ans air filter; and still says "open he hood" to access the battery. Tire pressures provided in the manual(10/10 F/R) are in conflict with the "warning" sticker on the vehicle (12/14 F/R).

The maintenance schedule charts have miles and km change interval labels reversed--I sent them a 30-point correction list 6 weeks ago, have received no response.

Other than that...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Homeowner A
      Is there a code reader available for the Coleman UTV 400?  I tried using the HUD ECU Hacker software and cables/adapters but no luck OBD to delphi 6 pin and KKL VAG as well as ELM327.  Will not connect.  I was able to get it to connect randomly a couple of times, but haven't been able to since.  I was able to clear and read the codes briefly.  I'm aware of the Tiny Scan 301 but it doesn't seem to be readily available.  There's a few out there but they are expensive.  
    • By Alien10
      I'm thinking of buying a snow blade for my Coleman Outfitter 550 (Hisun with Coleman stickers).
      Has anyone purchased a snow blade that can offer the make and model they bought and any comments, pros  cons etc.?
      Not 100% sure I'm going to buy, as the selection of blades for this model seems a bit thin on line. 
      Thoughts and comments welcomed.
      Thanks in advance.
    • By strike250
      I have the factory service manual available for the Buck 400. Just send me a message with your email and I'll get it to you. Although there is no charge for this, it would be great if  you would visit my website where you could donate any amount to help do things like this with others who need it. Again, there is no charge for this manual, and no obligation to donate. But if you did, I would thank you for sure. Have fun on the trails. www.warriorsoffroad.com
       
      Matt

    • By Homeowner A
      Could someone please recommend a reputable shop to troubleshoot and repair a Coleman UT 400 in the DFW TX area?  
    • By Jim Kessell
      Hi All
      Just installed a predator 670 on my Landmaster. My question is can I remove the low oil pressure wire fitting and plumb my mechanical gauge into that access point?
      Thanks in advance for your advice !!
      Jim
×
×
  • Create New...